Nissan Rogue (T33) 2021-Present Service Manual: Adas Control Unit :: Dtc/circuit Diagnosis
- C1f00-1c Control Unit
- C1f00-44 Control Unit
- C1f00-47 Control Unit
- C1f00-54 Hands Off Threshold Incomplete
- C1f00-71 Control Unit
- C1f02-16 Power Supply Circuit
- C1f03-23 Operation Sw Circ
- C1f03-72 Stop Lamp Relay
- C1f03-73 Stop Lamp Relay
- C1f04-48 Feb Ope Count Limit
- C1f04-61 Brake Sw/stop Lamp Sw
- C1f05-04 Front Camera Unit
- C1f05-49 Front Camera Unit
- C1f05-4b Front Camera Unit
- C1f05-54 Front Camera Unit
- C1f07-62 Side Radar (rear Right) Circuit
- C1f08-72 Stop Lamp Relay
- C1f36-55 Configuration
- C1f37-55 Switch Information
- C1f40-04 Ecm
- C1f41-84 Cvt
- C1f44-29 Bcm
- C1f48-16 Abs/tcs/vdc System
- C1f48-62 Abs/tcs/vdc System
- C1f5f-04 Distance Sensor
- C1f5f-08 Distance Sensor
- C1f5f-4b Distance Sensor
- C1f60-97 Can Comm Circuit
- C1f70-87 Ethernet Circuit
- C1f80-11 Steering Wheel Touch Sensor
- C1f80-88 Steering Wheel Touch Sensor
- C1f89-97 Side Radar Rear Lh
- C1f8b-47 Hd Map Module
- C1f8b-62 Hd Map Module
- C1f95-11 System Backup Function
- C1f96-29 Control Unit
- U1327-52 Mac Key
- U1327-54 Mac Key
- U19b1-87 Can Comm Circuit
- U19b2-87 Lin Comm Circuit
- U19b2-88 Lin Comm Circuit
- U19c1-87 Ethernet Circuit
- U2112-87 Can Comm Circuit
- U2140-57 Ecm
- U2143-57 Vcm/hpcm
- U214f-57 Mac Comm Error (bcm)
- U2150-87 Can Comm Circuit
- U2153-87 Can Comm Circuit
- U2752-88 Ethernet Circuit
- U2852-88 Ethernet Circuit
- U2952-88 Ethernet Circuit
- U2b52-88 Ethernet Circuit
- Power Supply and Ground Circuit
Other materials:
U007a-00 Control Module Comm Bus H Off
DTC Description
DESCRIPTIONCAN (Controller Area Network) is a serial
communication line for real time applications. It is an on-Nissan Ariya
vehicle multiplex communication line with high data communication speed
and excellent error detection ability. Modern Nissan Ariya vehicle is
equipped ...
Window washer fluid
Type A (if so equipped)
Type B (if so equipped)
For Type A systems on the Nissan Rogue, check the washer reservoir directly and refill with washer fluid when the level gets low.
For Type B systems, plug the center hole A of the cap/tube assembly with your finger and remove it from the re ...
Heated Oxygen Sensor 2
Component Function Check
PERFORM COMPONENT FUNCTION CHECK-1
Without CONSULT
Start engine and warm it up to normal operating temperature.
Turn ignition switch OFF and wait at least 10 seconds.
Start engine and keep the engine speed between 3,500 and 4,000 rpm for at least 1 minute u ...
