Nissan Rogue (T33) 2021-Present Service Manual: C1f07-62 Side Radar (rear Right) Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Adas Control Unit :: Dtc/circuit Diagnosis / C1f07-62 Side Radar (rear Right) Circuit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
C1F07 62 Side radar (Rear right) circuit Diagnosis condition When engine is running
Signal (terminal) Brake pedal position switch signal
Threshold Brake pedal position switch signal from ABS actuator and electric unit (control unit) is malfunction
Diagnosis delay time 5 second or more

POSSIBLE CAUSE

  • ABS actuator and electric unit (control unit)

  • ADAS control unit 2

FAIL-SAFE

The following systems are canceled.

  • Vehicle-to-vehicle distance control mode

  • Conventional (fixed speed) cruise control mode

  • Steering wheel assistance function

  • FEB

  • RAB

  • PFCW

  • LDP

  • Blind Spot Intervention

  • TSR

CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC “C1F07-62” is displayed with Network-DTC, first diagnose the Network-DTC.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine.

  2. Perform “All DTC Reading” with CONSULT.

  3. Check if the “C1F07-62” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.

Is “C1F07-62” detected as the current malfunction?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK STOP LAMP OPERATION

  1. Ignition switch ON.

  2. With operating the brake pedal, check that the stop lamp and high-mounted stop lamp is turned ON.

    Depressed : Stop lamp and high-mounted stop lamp ON
    Fully released : Stop lamp and high-mounted stop lamp OFF

Is the inspection result normal?

YES>>

Stop lamp circuit is normal. Replace ADAS control unit 2. Refer to Removal and Installation.

NO>>

Refer toDiagnosis Procedure .

    C1f05-54 Front Camera Unit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition   C1F05 54 Front camera unit (Front camera unit) Diagnosis ...
    C1f08-72 Stop Lamp Relay
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1F08 72 Stop lamp relay (Stop lamp relay) Diagnosis condition W...

    Other materials:

    C1f05-54 Front Camera Unit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition   C1F05 54 Front camera unit (Front camera unit) Diagnosis condition When AEB system is ON When driving the Nissan Ariya vehicle Signal (te ...

    P1564 Ascd Steering Switch
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1564 00 ASCD SW (ASCD SW) Diagnosis condition — Signal (terminal) ASCD steering switch signal Threshold ECM detects that input signal from t ...

    P06e6 Internal Control Module
    DTC Description DESCRIPTIONECM supplies a voltage of 5 V to some of the sensors systematically divided into 3 groups, respectively. Accordingly, when a short circuit develops in a sensor power source, a malfunction may occur simultaneously in the sensors belonging to the same group as the s ...