Nissan Rogue (T33) 2021-Present Service Manual: C1f08-72 Stop Lamp Relay
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| C1F08 | 72 |
Stop lamp relay (Stop lamp relay) |
Diagnosis condition | When engine is running |
| Signal (terminal) | Stop lamp request signal | |||
| Threshold | Stop lamp inactive state despite the outputting of a stop lamp request signal from ADAS control unit 2 | |||
| Diagnosis delay time | 1 second or less | |||
POSSIBLE CAUSE
-
BCM
-
ADAS control unit 2
FAIL-SAFE
The following system are cancelled.
-
Vehicle-to-vehicle distance control mode
-
Conventional (fixed speed) cruise control mode
-
Steering wheel assistance function
-
FEB
-
RAB
-
PFCW
-
LDP
-
Blind Spot Intervention
-
TSR
-
DAA
CONFIRMATION PROCEDURE
CHECK DTC PRIORITY
If DTC “C1F08-72� is displayed with Network-DTC, first diagnose the Network-DTC.
Is applicable DTC detected?
YES>>Perform diagnosis of applicable. Refer to DTC Index.
NO>>GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
NOTE:
To prevent the possibility of accident, perform component function check instead of DTC confirmation procedure.
-
Start the engine.
-
Perform the active test items “STOP LAMP 1� and “STOP LAMP 2� of “BCM� with CONSULT.
Is the inspection result normal?
YES-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
YES-2>>Confirmation after repair: INSPECTION END
NO>>Refer to DTC Diagnosis Procedure.
DTC Diagnosis Procedure
CHECK STOP LAMP CIRCUIT
Check the stop lamp circuit. Refer to Component Inspection.
Is the inspection result normal?
YES>>Replace ADAS control unit 2. Refer to Removal and Installation.
NO>>Repair or replace the malfunction part.
Other materials:
Rear Door Alert
The Rear Door Alert system helps remind the driver to check the rear seat(s) before leaving the Nissan Rogue. Under certain conditions, the system indicates that an object or passenger may still be in the rear seat.
The Rear Door Alert system is initially disabled.
The driver can enable the system ...
Back-Up Lamp Circuit
Component Function Check
CHECK BACK-UP LAMP OPERATION
Start the engine.
With operating the shift selector, check that the back-up lamp is turned ON.
Shift selector position: R range
: Back-up lamp ON
Shift selector position: Other than above
: Back-up lamp OFF
Is th ...
Remplacement de la pile de clé intelligente
AVERTISSEMENT
Risque en cas d’ingestion : l’ingestion d’une pile bouton peut entraîner des blessures graves, voire mortelles.
Une pile avalée peut provoquer des brûlures chimiques internes en seulement deux heures.
Conservez toujours les piles neuves et usagées hors de portée des ...
