Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Door Does Not Lock/unlock with Intelligent Key (one Key)

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Symptom Diagnosis :: Door Does Not Lock/unlock with Intelligent Key (one Key)

Description

All doors do not lock/unlock using Intelligent Key button. (One Intelligent Key has the symptom, other keys operate normally.)

NOTE:

Before starting diagnosis check that vehicle condition is as shown in “Conditions of Nissan Ariya vehicle�, and check each symptom.

SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY)

Door lock operation (remote keyless entry) Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) Unlock operation when approaching the Nissan Ariya vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna)
NG OK OK OK OK

DIAGNOSIS PROCEDURE

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE

Check Intelligent Key system symptom table.

Refer to Diagnosis Procedure.

>>

GO TO 2.

CHECK INTELLIGENT KEY OUTPUT SIGNAL

Use SIGNAL TECH II to check Intelligent Key output signal. For the inspection method and how to use SIGNAL TECH II, refer to “NISSAN/INFINITI SIGNAL TECH II USER GUIDE�.

YES>>

GO TO 3.

NO>>

Replace Intelligent Key.

REGISTER INTELLIGENT KEY

  1. Register the Intelligent Key again.

  2. Check operation after replacement.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

GO TO 4.

REPLACE INTELLIGENT KEY

  1. Replace the Intelligent Key and perform registration again.

  2. Check operation after replacement.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

GO TO 5.

REPLACE INTELLIGENT KEY UNIT

  1. Replace Intelligent Key unit. Refer to Removal and Installation.

  2. Check operation after replacement.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

    Symptom Diagnosis. Intelligent Key Button Operation Has Poor Range (all Keys)
    Description Intelligent Key button operation has poor range.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock ope...
    Symptom Diagnosis. Door Does Not Lock/unlock and Engine Does Not Start (one I-Key/req Sw/push Sw)
    Description All doors do not lock/unlock using door request switch and engine does not start when push-button ignition switch is pressed while carrying Intelligent Key. (One Int...

    Other materials:

    Dtc/circuit Diagnosis. Reclining Sensor
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Reclining motor position� in “Data monitor� mode of “DRIVER SEAT�. Check reclining sensor signal under the following conditions. Monitor item Condition Status Reclining motor position ...

    Ipdm E/r. Removal and Installation. Ipdm E/r
    Ipdm E/r Exploded View IPDM E/R cover A IPDM E/R IPDM E/R cover B IPDM E/R cover C IPDM E/R cover D IPDM E/R cover E : Pawl Removal and Installation REMOVALDisconnect the battery cable from the negative terminal. Disengage the fixing pawls and then remo ...

    Automatic Air Conditioning. Preparation. Preparation
    Preparation Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name   Description  — (NI-46534) Trim Tool Set Removing trim components Commercial Service Tools Tool name Description Power ...