Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Intelligent Key Button Operation Has Poor Range (all Keys)
Description
Intelligent Key button operation has poor range.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
| Door lock operation (remote keyless entry) | Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the Nissan Ariya vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| Poor range | OK | OK | OK | OK |
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK INTELLIGENT KEY LOW BATTERY WARNING
Check that the Intelligent Key low battery warning operates.
Is the Intelligent Key low battery warning operated?
YES>>GO TO 3.
NO>>Replace Intelligent Key battery. Refer to Removal and Installation.
CHECK INTELLIGENT KEY BATTERY
Check the Intelligent Key battery.
Refer to Component Inspection.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Replace Intelligent Key battery. Refer to Removal and Installation.
REMOTE AFTERMARKET DEVICE
-
If the Nissan Ariya vehicle is equipped with any interference-generating aftermarket device such as a vehicle security system, charger and remote engine starter etc., remove them.
-
Check operation after replacement.
Is the inspection result normal?
YES>>Inspection End.
NO>>GO TO 5.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check operation after replacement.
Is the inspection result normal?
YES>>Inspection End.
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials:
C1f96-29 Control Unit
DTC Description
DTC DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F96
29
CONTROL UNIT
(Control unit)
Diagnosis condition
When engine is running
Signal (terminal)
—
Threshold
ADAS control unit 2 internal malf ...
Chassis Can Communication 3 Circuit
Diagnosis Procedure
CHECK CAN DIAGNOSIS
Check the "Network Diagnosis" results from CONSULT to see that the
ITS CAN communication 1 circuit, ITS CAN communication 4 circuit and
diagnostic CAN communication circuit have no malfunction.
Are the ITS CAN communication 1 circuit, ITS CAN communicat ...
Eps/dast 3 Branch Line Circuit (chasssis Can Communication 1 Circuit)
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
Power steering control module
Harnes ...
