Nissan Rogue (T33) 2021-Present Service Manual: C1f05-54 Front Camera Unit
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| C1F05 | 54 |
Front camera unit (Front camera unit) |
Diagnosis condition |
|
| Signal (terminal) | — | |||
| Threshold | Camera aiming is not completed | |||
| Diagnosis delay time | 10 seconds or more | |||
POSSIBLE CAUSE
-
Front camera unit aiming is not adjusted
-
Front camera unit aiming adjustment has been interrupted
FAIL-SAFE
The following systems are canceled.
-
Vehicle-to-vehicle distance control mode
-
Conventional (fixed speed) cruise control mode
-
Steering wheel assistance function
-
AEB
-
LDW
-
I-LI
-
I-BSI
-
TSR
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
-
Start the engine.
-
Drive the Nissan Ariya vehicle at 5 km/h (3 MPH) or more.
CAUTION:
Always drive safely.
-
Perform “All DTC Reading� with CONSULT.
-
Check if the “C1F05-54� is detected as the current malfunction in “Self Diagnostic Result� of “ICC/ADAS 2�.
Is “C1F05-54� detected as the current malfunction?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CAMERA AIMING ADJUSTMENT
-
Perform the camera aiming. Refer to Work Procedure.
-
Erase all self-diagnosis results with CONSULT.
-
Perform “All DTC Reading�.
-
Check if the “C1F05-54� is detected in “Self Diagnostic Result� of “ICC/ADAS 2�.
Is “C1F05-54� detected?
YES>>Replace the front camera unit. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
P1536 Ascd System
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P1536
00
Cruise control
(Cruise control)
Diagnosis condition
Ignition switch ON
Signal
CAN communication signal
Threshold
ECM cannot receive a ...
System Description. Component Parts. Heated Steering Wheel System
Heated Steering Wheel System
Component Parts Location
A.
Center of instrument panel (view with A/C switch assembly and center vent finisher removed)
No.ComponentFunction
1.
Heated steering wheel
Refer to Heated Steering Wheel.
2.
A/C switch assembly (heated steering wheel switch)
Ref ...
Service After Replacing or Removing Engine Parts
Description
X: Applicable Part name Service performed Required service Reference
Replacement Removal
ECM
X
—
Additional service when replacing ECM
Work Procedure
Fuel injector offset learning
Work Procedure
Turbocharger wastegate control solenoid valve d ...
