Nissan Rogue (T33) 2021-Present Service Manual: Service After Replacing or Removing Engine Parts

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Basic Inspection / Service After Replacing or Removing Engine Parts

Description

X: Applicable

Part name Service performed Required service Reference
Replacement Removal
 
ECM X — Additional service when replacing ECM Work Procedure
Fuel injector offset learning Work Procedure
Turbocharger wastegate control solenoid valve data initialization Work Procedure
Electric intake valve timing control module X — Electric IVT control actuator position learning Work Procedure
Electric intake valve timing control actuator X —
Crankshaft position sensor X —
Intake camshaft position sensor X —
Exhaust camshaft position sensor X —

Engine mechanical parts

  • Timing chain

  • Intake/Exhaust camshaft

  • Intake/Exhaust camshaft sprocket

  • Piston

  • Connecting rod

  • Crankshaft

 X X
Accelerator pedal X — Accelerator pedal released position learning Work Procedure
Electric throttle control actuator X X* Throttle valve closed position learning Work Procedure
— Idle air volume learning Work Procedure
Air fuel ratio initial learning Work Procedure
Mass air flow sensor X — Air fuel ratio initial learning Work Procedure
Air fuel ratio sensor 1
Fuel injector X — Fuel injector offset learning Work Procedure
Engine assembly X — Idle air volume learning Work Procedure
Air fuel ratio initial learning Work Procedure
Electric IVT control actuator position learning Work Procedure
Turbocharger assembly X — Turbocharger wastegate control solenoid valve data initialization Work Procedure
VCR control module X — VCR base position learning Work Procedure
VCR actuator X —
Engine oil X — Engine oil data reset Work Procedure

*: Cleaning in electric throttle control actuator

    Basic Inspection
    Work Procedure INSPECTION START Check service records for any recent repairs that may indicate a related malfunction, or a current need for scheduled maintenance. Open engine ho...
    Additional Service When Replacing Ecm
    Description When replacing ECM, the following procedure must be performed.CAUTION: When replacing the ECM, always replace it with a new one. The functions controlled by the ECM ...

    Other materials:

    I-BSI system operation
    Side indicator light I-BSI ON indicator I-BSI warning indicator Vehicle information display ProPILOT Assist switch The I-BSI system functions above approximately 37 MPH (60 km/h). If a vehicle enters the detection zone, the side indicator light turns on. If the turn signal is acti ...

    How to Erase Permanent Dtc
    Description OUTLINEWhen a DTC is stored in control moduleWhen a DTC is stored in control module and MIL is ON, a permanent DTC is erased with MIL shutoff if the same malfunction is not detected after performing the driving pattern for MIL shutoff three times in a raw. *1: When the same mal ...

    Dtc/circuit Diagnosis. U1327-54 Mac Key Update
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition U1327-54 MAC key update (Message authentication code key update) Diagnosis condition - Signal (terminal) - Threshold MAC key is not written after BC ...