Nissan Rogue (T33) 2021-Present Service Manual: Kr15ddt :: Basic Inspection
- Diagnosis and Repair Workflow
- Basic Inspection
- Service After Replacing or Removing Engine Parts
- Additional Service When Replacing Ecm
- Vin Registration
- Accelerator Pedal Released Position Learning
- Air Fuel Ratio Initial Learning
- Egr Volume Control Valve Closed Position Learning
- Electric Ivt Control Actuator Position Learning
- Fuel Injector Offset Learning
- Idle Air Volume Learning
- Throttle Valve Closed Position Learning
- Vcr Base Position Learning
- Turbocharger Wastegate Control Solenoid Valve Data Initialization
- Mixture Ratio Self-Learning Value Clear
- Mac Key Writing
- Engine Oil Data Reset
- Fuel Pressure Check
- How to Set Srt Code
- How to Erase Permanent Dtc
Other materials:
C10b4-98 Overheat
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C10B4
98
Overheat
(Overheat)
Diagnosis condition
When ignition switch is ON
Signal (terminal)
—
Threshold
System is high temperature status.
...
Basic Inspection. Additional Service When Replacing Air Bag Diagnosis Sensor Unit
Description
After replaced air bag diagnosis sensor unit, it is necessary to
perform control unit configuration with CONSULT. For details, refer to
Work Procedure.
Work Procedure
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
...
Fuel Injector Relay
Component Inspection
CHECK FUEL INJECTOR RELAY
Turn ignition switch OFF.
Remove fuel injector relay. Refer to Component Parts Location.
Check the continuity between fuel injector relay terminals as per the following conditions.
Fuel injector relay Condition Continuity
+ −
...