Nissan Rogue (T33) 2021-Present Service Manual: Accelerator Pedal Released Position Learning

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Basic Inspection / Accelerator Pedal Released Position Learning

Description

Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position sensor or ECM is disconnected.

Work Procedure

START

  1. Make sure that accelerator pedal is fully released.

  2. Turn ignition switch ON and wait at least 2 seconds.

  3. Turn ignition switch OFF and wait at least 10 seconds.

  4. Repeat steps 2 to 3 for three times.

>>

END

    Vin Registration
    Description VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced.NOTE: Accurate VIN which is registered in ECM may be requi...
    Air Fuel Ratio Initial Learning
    Description Air fuel ratio initial learning of ECM to learn the air fuel ratio that keeps each engine idle speed within the specific range. It must be performed under any of the...

    Other materials:

    Variable Compression Ratio Motor
    Component Inspection CHECK VCR MOTOR Turn ignition switch OFF. Disconnect VCR motor harness connector. Check the continuity between VCR motor terminals as per the following. VCR motor Continuity Terminal 2 3 Existed 1 3 1 Check harness for short ...

    Preparation
    Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description KV10115801 (NI-38956) Oil filter wrench Removing and installing oil filter a: 64.3 mm (2.531 in) KV311039S0 ( — ) Chargin ...

    Ssg Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the sub starter & generator for damage, bend and loose connection (unit side and connector side). Is the inspect ...