Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Air cleaner

Nissan Rogue air cleaner

To remove the filter on the Nissan Rogue, release the lock pins 1 and pull the unit upward 2.

The viscous paper filter element (if equipped) is not designed to be cleaned and reused. The dry paper type element may be cleaned and reused when its condition allows. Replace the filter according to the maintenance schedule in the “Maintenance and schedules� section.

When installing a new filter, wipe the inside of the air cleaner housing and the cover with a damp cloth.

WARNING

  • Running the engine without the air cleaner filter installed can cause burns or injury. The filter prevents debris from entering the intake and helps stop flame in case of backfire. Never operate the Nissan Rogue with the air cleaner removed.
  • Do not pour fuel into the throttle body or attempt to start the engine with the air cleaner removed, as this can lead to serious injury.
    Window washer fluid
    Type A (if so equipped) Type B (if so equipped) For Type A systems on the Nissan Rogue, check the washer reservoir directly and refill with washer fluid when the level gets low....
    Windshield wiper blades
    Cleaning Basic information If the windshield of your Nissan Rogue remains unclear after using the washer, or if the wiper blades chatter, wax or debris may be present on the gla...

    Other materials:

    Basic Inspection. Diagnosis and Repair Work Flow
    Work Flow OVERALL SEQUENCEDETAILED FLOWINTERVIEW CUSTOMER Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. REPRODUCE THE MALFUNCTION INFORMATION Reproduce the malfunction on the ...

    Additional Service When Replacing Side Radar
    Work Procedure Always perform the side radar configuration after replacing the side radar.SIDE RADAR CONFIGURATION Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual. >> GO TO 2. SIDE RADAR ALIGNMENT Perform the side radar alignment with ...

    Main Line Between Avm and Sonar Circuit
    Diagnosis Procedure CHECK HARNESS CONTINUITY (OPEN CIRCUIT) Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect the following harness connectors. Around view monitor control unit Sonar control unit ADAS control unit 2 ...