Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Window washer fluid

Nissan Rogue window washer fluid
Type A (if so equipped)

Nissan Rogue washer system
Type B (if so equipped)

For Type A systems on the Nissan Rogue, check the washer reservoir directly and refill with washer fluid when the level gets low.

For Type B systems, plug the center hole A of the cap/tube assembly with your finger and remove it from the reservoir. If no fluid appears inside the tube, add washer solution.

A quality washer solvent can improve cleaning, and during winter it is advisable to use a suitable windshield washer antifreeze. Always follow the manufacturer’s mixing instructions.

Refill the window washer reservoir regularly. Add fluid when the low-level warning appears (if equipped) and expect to refill more often if driving in dusty, muddy, or winter conditions where the Nissan Rogue uses more washer spray.

Recommended fluid: Genuine NISSAN Windshield Washer Concentrate Cleaner & Antifreeze or equivalent.

CAUTION

  • Do not substitute engine antifreeze for washer solution — it can damage painted surfaces.
  • Avoid pouring full-strength washer concentrates directly into the reservoir. Some methyl-alcohol mixtures may permanently stain the grille if spilled.
  • Always pre-mix concentrates with water to the recommended ratio before filling the reservoir. Do not use the reservoir itself for mixing.
    Window washer fluid
    Type A (if so equipped) Type B (if so equipped) For Type A systems on the Nissan Rogue, check the fluid level directly in the washer reservoir and refill when the level is low. ...
    Air cleaner
    To remove the filter on the Nissan Rogue, release the lock pins 1 and pull the unit upward 2. The viscous paper filter element (if equipped) is not designed to be cleaned and re...

    Other materials:

    Intelligent Forward Collision Warning (I-FCW)
    Basic information WARNING Failure to follow the warnings and instructions for proper use of the I-FCW system on the Nissan Rogue could result in serious injury or death. The I-FCW system helps alert the driver before a potential collision but cannot prevent one. The driver must remain attentive, ...

    P0443 Evap Canister Purge Volume Control Solenoid Valve
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0443 00 PURG VOLUME CONT/V (EVAP system purge control valve "A" circuit) A Diagnosis condition Engine cold start Signal (terminal) — Thresho ...

    Configuration
    Description Vehicle specification needs to be written with CONSULT because it is not written after replacing the ABS actuator and electric unit (control unit).The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the ser ...