Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U2218-87 Can Comm Err (intelligent Key)

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / Dtc/circuit Diagnosis :: U2218-87 Can Comm Err (intelligent Key)

DTC Description

DESCRIPTION

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC Detection Condition
U2218–87

CAN comm err (Intelligent Key)

[CAN communication error (Intelligent Key)] 		Diagnosis condition Ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold BCM cannot communicate CAN communication signal.
Diagnosis delay time 2 seconds or more.

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

CHECK SELF-DIAG RESULT

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “BCM”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

Inspection End.

    Dtc/circuit Diagnosis. U2176-87 Can Comm Err (ccm/st Angle Sensor)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...
    Dtc/circuit Diagnosis. U2250-87 Can Comm Err (air Bag)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...

    Other materials:

    Comment activer/désactiver le système de sonar
    Commandes au volant (côté gauche) Écran d’informations du véhicule Le système de sonar du Nissan Rogue est automatiquement activé lorsque le contact d’allumage est placé sur la position ON et que le levier de vitesses est engagé sur D (conduite) ou R (marche arrière). Pou ...

    Dtc/circuit Diagnosis. B2416-15 Touch Sensor Circuit Rh Open
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2416-15 Touch sensor circuit RH open (Touch sensor circuit right hand open) Diagnosis condition All times Signal (terminal) Touch sensor RH signal Thr ...

    Power Supply and Ground Circuit
    Diagnosis Procedure CHECK FUSIBLE LINK Ignition switch OFF. Check that the following fusible links are not blown (open): Signal name Fusible link No. Capacity Battery power supply E 100A D 100A B 140A Z 30A Is the fusible link blown (open)? ...