Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U2176-87 Can Comm Err (ccm/st Angle Sensor)

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / Dtc/circuit Diagnosis :: U2176-87 Can Comm Err (ccm/st Angle Sensor)

DTC Description

DESCRIPTION

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC Detection Condition
U2176-87

CAN comm err (CCM/ST angle sensor)

[CAN communication error (chassis control module/steering angle sensor)] 		Diagnosis condition Ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold BCM cannot communicate CAN communication signal.
Diagnosis delay time 2 seconds or more.

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

CHECK SELF-DIAG RESULT

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “BCM”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

Inspection End.

    Dtc/circuit Diagnosis. U2176-57 Can Comm Err (ccm/st Angle Sensor)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition U2176-57 CAN comm err (CCM/ST angle sensor) [Control area ne...
    Dtc/circuit Diagnosis. U2218-87 Can Comm Err (intelligent Key)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...

    Other materials:

    Operation
    Switch Name and Function OPERATION AND DISPLAY OF AUTOMATIC AIR CONDITIONING SYSTEMDisplay: Display in A/C switch assembly Air conditioning operation status is indicated on display in A/C switch assembly. Air conditioning status display screen is indicated when MODE switch is pressed while ...

    C10b2-01 Parking Brake Switch
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C10B2 01 Parking brake switch (Parking brake switch) Diagnosis condition When ignition switch is ON Signal (terminal) Paring brake switch Threshold ...

    System temporarily unavailable
    When any of the following alerts appear on the vehicle information display of the Nissan Rogue, a chime will sound and the I-BSI system will automatically switch off for safety. "Unavailable Slippery Road": Occurs when the VDC system (except traction control) or the ABS is actively operating. ...