Nissan Rogue (T33) 2021-Present Service Manual: Intake Air Temperature Sensor 2

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Intake Air Temperature Sensor 2

Component Inspection

CHECK INTAKE AIR TEMPERATURE SENSOR 2

  1. Turn ignition switch OFF.

  2. Disconnect turbocharger boost sensor harness connector.

  3. Check resistance between turbocharger boost sensor terminals as follows.

    Turbocharger boost sensor Condition Resistance (kΩ)
    + −
    Terminals
    4 3 Temperature [°C (°F)] 25 (77) 1.94 – 2.06

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace turbocharger boost sensor (with intake air temperature sensor 2). Refer to Exploded View.

    Intake Air Temperature Sensor 1
    Component Inspection CHECK INTAKE AIR TEMPERATURE SENSOR Turn ignition switch OFF. Disconnect mass air flow sensor harness connector and reconnect it again. Turn ignition switch...
    Intake Camshaft Position Sensor
    Component Inspection CHECK INTAKE CAMSHAFT POSITION SENSOR -1 Turn ignition switch OFF. Loosen the fixing bolt of the sensor. Disconnect intake camshaft position sensor harness ...

    Other materials:

    System Description. Component Parts. Heated Steering Wheel System
    Heated Steering Wheel System Component Parts Location A. Center of instrument panel (view with A/C switch assembly and center vent finisher removed) No.ComponentFunction 1. Heated steering wheel Refer to Heated Steering Wheel. 2. A/C switch assembly (heated steering wheel switch) Ref ...

    Precautions on seat belt usage
    Wearing your seat belt correctly — sitting upright, positioned well back in the seat, and keeping both feet on the floor — significantly reduces the risk of injury or death in an accident. When used properly, seat belts work together with your Nissan Rogue’s safety systems, including suppleme ...

    Fuel Injector Relay
    Component Inspection CHECK FUEL INJECTOR RELAY Turn ignition switch OFF. Remove fuel injector relay. Refer to Component Parts Location. Check the continuity between fuel injector relay terminals as per the following conditions. Fuel injector relay Condition Continuity + − ...