Nissan Rogue (T33) 2021-Present Service Manual: Intake Air Temperature Sensor 1

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Intake Air Temperature Sensor 1

Component Inspection

CHECK INTAKE AIR TEMPERATURE SENSOR

  1. Turn ignition switch OFF.

  2. Disconnect mass air flow sensor harness connector and reconnect it again.

  3. Turn ignition switch ON.

  4. Select “DATA MONITOR” mode with CONSULT.

  5. Check that “Intake air temperature” indicates as per following condition.

    Monitor item Condition Value Values
    Intake air temperature Temperature [°C (°F)] 25 (77) 20 - 30°C (68 - 86°F)
    80 （176） 75 - 85°C (167 - 185°F)

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace mass air flow sensor (with intake air temperature sensor). Refer to Exploded View.

    Information Display (ascd)
    Component Function Check CHECK INFORMATION DISPLAY Start engine. Press MAIN switch on ASCD steering switch. Drive the Nissan Ariya vehicle at more than 40 km/h (25 MPH). CAUTION...
    Intake Air Temperature Sensor 2
    Component Inspection CHECK INTAKE AIR TEMPERATURE SENSOR 2 Turn ignition switch OFF. Disconnect turbocharger boost sensor harness connector. Check resistance between turbocharge...

    Other materials:

    Symptom Diagnosis. Driver Side Power Window Does Not Operate
    Diagnosis Procedure CHECK POWER WINDOW MAIN SWITCH POWER SUPPLY AND GROUND CIRCUIT Check power window main switch power supply and ground circuit. Refer to Diagnosis Procedure. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. CHE ...

    U2259 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2259 87 CAN comm err (steering control unit) [CAN comm err (steering control unit)] Diagnosis condition Ignition switch ON Signal (terminal) CAN commu ...

    P06b3 Sensor Power Supply 2
    DTC Description DESCRIPTIONECM supplies a voltage of 5 V to some of the sensors systematically divided into 3 groups, respectively. Accordingly, when a short circuit develops in a sensor power source, a malfunction may occur simultaneously in the sensors belonging to the same group as the s ...