Nissan Rogue (T33) 2021-Present Service Manual: Information Display (ascd)
Component Function Check
CHECK INFORMATION DISPLAY
-
Start engine.
-
Press MAIN switch on ASCD steering switch.
-
Drive the Nissan Ariya vehicle at more than 40 km/h (25 MPH).
CAUTION:
Always drive vehicle at a safe speed.
-
Press SET— switch.
-
Check that the reading of the speedometer shows the same value as the set speed indicated in the information display while driving the Nissan Ariya vehicle on a flat road.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK DTC
-
Check that DTC UXXXX is not displayed.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Perform trouble diagnosis for DTC UXXXX. Refer to DTC Index.
CHECK DTC WITH COMBINATION METER
Check DTC with combination meter. Refer to DTC Index (Full TFT meter) or DTC Index (7 inch information display).
Is the inspection result normal?
YES>>GO TO 3.
NO>>Perform trouble diagnosis for DTC indicated.
CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to Intermittent Incident.
Is the inspection result normal?
YES>>Replace combination meter. Refer to Removal and Installation (Full TFT meter) or Removal and Installation (7 inch information display).
NO>>Repair or replace error-detected parts.
Other materials:
Dtc/circuit Diagnosis. U2152-87 Can Comm Err (adas Control Unit 2)
DTC Description
DESCRIPTIONCAN (Controller Area Network) is a serial
communication line for real time applications. It is an on-Nissan Ariya
vehicle multiplex communication line with high data communication speed
and excellent error detection ability. Modern Nissan Ariya vehicle is
equipped ...
Windshield wiper blades
Cleaning
Basic information
If the windshield of your Nissan Rogue remains unclear after using the washer, or if the wiper blades chatter, wax or debris may be present on the glass or the blades.
Clean the windshield with washer solution or mild detergent. A clean surface will not form water be ...
Dtc/circuit Diagnosis. Unlock Sensor
Diagnosis Procedure
CHECK UNLOCK SENSOR INPUT SIGNAL
Ignition switch OFF.
Disconnect front door lock assembly LH connector.
Check voltage between front door lock assembly LH harness connector and ground.
(+) (–)
Voltage
(Approx.)
Front door lock assembly LH
Connector T ...
