Nissan Rogue (T33) 2021-Present Service Manual: Fuel Injector Relay
Component Inspection
CHECK FUEL INJECTOR RELAY
-
Turn ignition switch OFF.
-
Remove fuel injector relay. Refer to Component Parts Location.
-
Check the continuity between fuel injector relay terminals as per the following conditions.
Fuel injector relay Condition Continuity + − Terminal 1 2 12 V direct current supply between terminals 3 and 4 Existed No current supply Not existed
Is the inspection result normal?
YES>>INSPECTION END
NO>>Replace fuel injector relay.
Other materials:
Dtc/circuit Diagnosis. B2010-1c Battery Voltage
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B2010-1C
Battery voltage
(Battery voltage)
Diagnosis condition
All times
Signal (terminal)
Intelligent Key unit battery power supply signal
Threshold
...
Air Fuel Ratio Initial Learning
Description
Air fuel ratio initial learning of ECM to learn the air fuel ratio
that keeps each engine idle speed within the specific range. It must be
performed under any of the following conditions:
When ECM is replaced*
When engine assembly is replaced*
When electric throttle con ...
Basic Inspection. Tire Pressure Sensor Id Registration
Description
This procedure must be performed.
After replacement of a tire pressure sensor or BCM.
After replacement of tire or road wheel.
NOTE:
ID registration is unnecessary if there are no change in
the positions of each wheels (tire pressure sensors) before wheel
removal and after ...