Nissan Rogue (T33) 2021-Present Service Manual: Fuel Pump

Component Inspection

CHECK FUEL PUMP

  1. Turn ignition switch OFF.

  2. Disconnect “fuel level sensor unit and fuel pump� harness connector.

  3. Check the resistance between “fuel level sensor unit and fuel pump� terminals as follows.

    Fuel level sensor unit and fuel pump Condition Resistance
    Terminal
    6 5 Temperature 25°C (77°F) 0.2 – 5.0 Ω

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace “fuel level sensor unit and fuel pump�. Refer to Removal and Installation(AWD), Removal and Installation(FWD).

    Fuel Injector Relay
    Component Inspection CHECK FUEL INJECTOR RELAY Turn ignition switch OFF. Remove fuel injector relay. Refer to Component Parts Location. Check the continuity between fuel injecto...
    Fuel Pump Control Module
    Component Inspection CHECK FUEL PUMP CONTROL MODULE (FPCM) Check the voltage between FPCM terminals under the following conditions. FPCM Condition Voltage (Approx.) Connector + ...

    Other materials:

    Removal and Installation. Electrically-Driven Intelligent Brake Unit
    Exploded View Reservoir cap Oil strainer Electrically-driven intelligent brake unit Clevis Gasket     : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal & Installation REMOVALCAUTION: While electrically-driven ...

    P2122 App Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2122 00 APP SEN 1/CIRC (Throttle/Pedal position sensor/switch D circuit low) Diagnosis condition Engine running at idle Signal (terminal) Accelerator ...

    Vehicle information display warnings and indicators
    Engine start operation indicator This indicator appears when the shift position is set to P (Park). It informs the driver that the engine will start when the ignition switch is pushed while depressing the brake pedal. The Nissan Rogue engine can be started directly in any ignition switch position. ...