Nissan Rogue (T33) 2021-Present Service Manual: Fuel Pump Control Module

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Fuel Pump Control Module

Component Inspection

CHECK FUEL PUMP CONTROL MODULE (FPCM)

  1. Check the voltage between FPCM terminals under the following conditions.

    FPCM Condition

    Voltage

    (Approx.)
    Connector + −
    Terminal
    B97 6 5 For 1 second after turning ignition switch ON 9.9 V
    More than 1 second after turning ignition switch ON 0 V
    Idle speed 9.9 V

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace FPCM. Refer to Removal and Installation.

    Fuel Pump
    Component Inspection CHECK FUEL PUMP Turn ignition switch OFF. Disconnect “fuel level sensor unit and fuel pump” harness connector. Check the resistance between “fuel leve...
    Fuel Rail Pressure Sensor
    Component Inspection CHECK FUEL RAIL PRESSURE (FRP) SENSOR With CONSULT Turn ignition switch OFF. Reconnect harness connector disconnected. Start engine and warm it up to normal...

    Other materials:

    Steering Switch Signal a Circuit
    Component Function Check CHECK COMBINATION METER INPUT SIGNAL CONSULT Ignition switch ON. Select “Steering switch input” in “Data monitor” mode of “M&A”. Check that the function operates normally according to the following conditions: Condition Value CONTRO ...

    Preparation
    Commercial Service Tools Tool Description Power tool Loosening screws Sealant or/and Lubricant Name Description Primer (3M K500, K520 or equivalent) Primer for attaching sonar sensor holder to bumper ...

    U2118-87 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U2118 87 CAN communication error (Intelligent Key unit) Diagnosis condition When ignition switch is ON. Signal (terminal) CAN communication signal Threshold Not receiving from i ...