Nissan Rogue (T33) 2021-Present Service Manual: P01f0 Engine Coolant Temperature

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P01F0 00

Coolant temperature

(Coolant temperature relapsed below diagnostic monitoring temperature)
Diagnosis condition
  • After engine warmed up

  • Nissan Ariya Vehicle speed is more than 60km/h (37 MPH) and no fuel cut

Signal (terminal) Engine coolant temperature sensor signal
Threshold When the engine coolant temperature is lower than threshold value, after Nissan Ariya vehicle is driven at 60km/h (37 MPH) or more for certain period. Make sure that the engine is warmed up to normal operating temperature before driving. Make sure that the engine is warmed up to normal operating temperature before driving.
Diagnosis delay time 40 seconds or more

POSSIBLE CAUSE

  • Thermostat

  • Engine coolant temperature sensor 1

  • Leakage from sealing portion of thermostat

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

NOTE:

Never refuel before and during the following procedure.

CHECK DTC PRIORITY

If DTC P01F0 is displayed with DTC P0116, P0117, P0118, or P0128, first perform the trouble diagnosis for DTC P0116, P0117, P0118, or P0128.

Is other DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Start engine and warm it up to the normal operating temperature.

  2. Maintain the hold Nissan Ariya vehicle speed at more than 60 km/h (37 MPH) for at least 40 consecutive seconds.

    CAUTION:

    Always drive Nissan Ariya vehicle in safe manner according to traffic conditions and obey all traffic laws.

    NOTE:

    Keeping the accelerator pedal as steady as possible at approximately more than 1/8.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK ENGINE COOLANT TEMPERATURE SENSOR 1

Check the engine coolant temperature sensor 1. Refer to Component Inspection.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace engine coolant temperature sensor 1. Refer to Removal and Installation.

CHECK THERMOSTAT

Check the thermostat. Refer to Exploded View.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace thermostat.

    P0196 Eot Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0196 00 EOT SENSOR (Engine oil temperature sensor A range/perfo...
    P0201 Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0201 00 INJECTOR CIRC-CYL1 Diagnosis condition Engine running a...

    Other materials:

    Windshield deicer switch
    Example The windshield deicer helps remove ice when the wiper is frozen to the glass — a useful function during winter driving in your Nissan Rogue. Start the engine and press the switch. The indicator light A illuminates, and the deicer will operate for about 20 minutes. The rear window defro ...

    P1217 Engine Over Temperature
    DTC Description DTC DETECTION LOGICIf the cooling fan or another component in the cooling system malfunctions, engine coolant temperature will rise.When the engine coolant temperature reaches an abnormally high temperature condition, a malfunction is indicated. DTC CONSULT screen terms (Troubl ...

    How to Use This Manual. Tightening Torque of Standard Bolts
    Description This vehicle has both new standard based on ISO* and previous standard bolts/nuts. There are some differences between these two types of bolts/ nuts; shape of the head, grade of strength, hexagonal width across flats and the standard tightening torque. For guidance in discrimin ...