Nissan Rogue (T33) 2021-Present Service Manual: Meter Speaker Signal Circuit

Diagnosis Procedure

CHECK METER SPEAKER CIRCUIT FOR OPEN

  1. Ignition switch OFF.

  2. Disconnect combination meter harness connector and meter speaker harness connector.

  3. Check the continuity between combination meter harness connector and meter speaker harness connector.

    Combination meter Meter speaker Continuity
    Connector Terminal Connector Terminal
    M76 3 M83 1 Yes
    4 4

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace malfunctioning parts.

CHECK METER SPEAKER CIRCUIT FOR SHORT TO GROUND

Check the continuity between meter speaker harness connector and ground.

Terminals Continuity
(+) (−)
Meter speaker
Connector Terminal
M83 1 Ground No
4

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace malfunctioning parts.

CHECK METER SPEAKER CIRCUIT FOR SHORT TO POWER SUPPLY

  1. Ignition switch ON.

  2. Check the voltage between meter speaker harness connector and ground.

Terminals

Voltage

(Approx.)
(+) (−)
Meter speaker
Connector Terminal
M83 1 Ground 0 V
4

Is the inspection result normal?

YES>>

Replace meter speaker. Refer to Removal and Installation.

NO>>

Repair or replace malfunctioning parts.

    Power Supply and Ground Circuit
    Combination Meter Diagnosis Procedure CHECK FUSE Check that the following fuses are not blown: Unit Location Fuse No. Capacity Combination meter Fuse block (J/B) 29 5A 6 5A Is t...
    Steering Switch Signal a Circuit
    Component Function Check CHECK COMBINATION METER INPUT SIGNAL CONSULT Ignition switch ON. Select “Steering switch input” in “Data monitor” mode of “M&A”. Check t...

    Other materials:

    Electric Intake Valve Timing Control Module
    Values On The Diagnosis Tool VALUES ON THE DIAGNOSIS TOOLNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Numerical values in the following table are re ...

    Symptom Diagnosis. Ignition Position Warning Function Does Not Operate
    Diagnosis Procedure CHECK POWER DOOR LOCK OPERATION Check door lock/unlock using door lock/unlock switch. Does door lock/unlock with door lock/unlock switch? YES>> GO TO 2. NO>> Refer to Diagnosis Procedure. CHECK DOOR SWITCH Check front door switch (front LH). Refer to Compo ...

    Rear Final Drive: R145. Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
    Noise, Vibration and Harshness (nvh) Troubleshooting NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference Noise Vibration Gear tooth rough × – Inspectio ...