Nissan Rogue (T33) 2021-Present Service Manual: Power Supply and Ground Circuit

Combination Meter

Diagnosis Procedure

CHECK FUSE

Check that the following fuses are not blown:

Unit Location Fuse No. Capacity
Combination meter Fuse block (J/B) 29 5A
6 5A

Is the fuse blown?

YES>>

Replace the blown fuse after repairing the affected circuit.

NO>>

GO TO 2.

CHECK POWER SUPPLY CIRCUIT

  1. Disconnect combination meter harness connector.

  2. Check voltage between combination meter harness connector and ground.

    (+) (–) Ignition switch position
    Combination meter
    Connector Terminal OFF ON START
    M76 5 Ground Battery voltage Battery voltage Battery voltage
    6 0V Battery voltage Battery voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connector.

CHECK GROUND CIRCUIT

  1. Ignition switch OFF.

  2. Check continuity between combination meter harness connector and ground.

    Combination meter Ground Continuity
    Connector Terminal
    M76 7 Yes

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Repair harness or connector.

    U2118-87 Can Comm Circuit
    DTC Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-Nissan Ariya vehicle multiplex communication system with hi...
    Meter Speaker Signal Circuit
    Diagnosis Procedure CHECK METER SPEAKER CIRCUIT FOR OPEN Ignition switch OFF. Disconnect combination meter harness connector and meter speaker harness connector. Check the conti...

    Other materials:

    System
    System Description Chassis control to integrally control the driving system was adopted. Chassis control module inputs the necessary information for control from CAN communication and each switch and integrally controls each system. Refer to the following table for systems controlled a ...

    U1ca2-08 Lin Communication 3
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1CA2-08 LIN communication 3 (Local interconnect network communication 3) Diagnosis condition Ignition switch ON Signal (Terminal) LIN (door motor) signal ...

    Perte rapide de pression d'air
    Une perte rapide de pression d'air ou un « éclatement » de pneu peut survenir sur le Nissan Rogue lorsque le pneu est crevé ou gravement endommagé, par exemple après avoir heurté un trottoir, roulé sur un nid-de-poule profond ou rencontré un obstacle sur la chaussée. La conduite prolongée ...