Nissan Rogue (T33) 2021-Present Service Manual: P0531 A/c Refrigerant Pressure Sensor
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P0531 | 00 |
REFRIGERANT PRESS SENSOR A (A/C refrigerant pressure sensor A circuit range/performance |
Diagnosis condition | Engine running at idle |
| Signal (terminal) | Refrigerant pressure sensor signal | |||
| Threshold | ECM detects that input signal from the refrigerant pressure sensor is out of the specified range | |||
| Diagnosis delay time | 5 seconds | |||
POSSIBLE CAUSE
-
Harness or connectors
-
Refrigerant pressure sensor
-
Sensor power supply 2 circuit
FAIL-SAFE
Not applicable
DTC Confirmation Procedure
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 11 V or more under ignition switch OFF condition.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Start engine and run it for at least 10 seconds at idle speed.
-
Check 1st trip DTC.
Is 1st trip DTC detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK REFRIGERANT PRESSURE SENSOR
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Replace refrigerant pressure sensor. Refer to Removal and Installation.
Other materials:
Periodic Maintenance. Front Disc Brake
Brake Pad
Inspection and Adjustment
INSPECTIONCheck brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary. Wear thickness
: Refer to Front Disc Brake.
ADJUSTMENTBurnish contact surfaces
between disc rotor and brake pads according to the follow ...
Huile moteur
Vérification du niveau d'huile moteur
1. Garez le Nissan Rogue sur une surface plane et serrez fermement le frein de stationnement.
2. Laissez le moteur fonctionner jusqu’à ce qu’il atteigne sa température normale de fonctionnement.
3. Arrêtez le moteur et patientez au minimum 10 mi ...
Feux
Informations de base
Spot de lecture avant
Éclairage de miroir de courtoisie (si équipé)
Plafonnier (si équipé)
Clignotant latéral (si équipé)
Éclairage individuel arrière (si équipé)
Phare – feu de route
Phare – feu de croisement
Feu de stationnement avant / ...
