Nissan Rogue (T33) 2021-Present Service Manual: P0532 A/c Refrigerant Pressure Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P0532 A/c Refrigerant Pressure Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P0532 00

REFRIGERANT PRESS SENSOR A

(A/C refrigerant pressure sensor A circuit low) 		Diagnosis condition —
Signal (terminal) Refrigerant pressure sensor signal
Threshold An excessively low voltage from the sensor is sent to ECM.
Diagnosis delay time 5 seconds

POSSIBLE CAUSE

  • Harness or connectors

  • Refrigerant pressure sensor

  • Sensor power supply 2 circuit

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

PRECONDITIONING-1

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more under ignition switch OFF condition.

>>

GO TO 2.

PRECONDITIONING-2

Check the following conditions:

Ambient temperature 0°C (32°F) or more

Is the condition satisfied?

YES>>

GO TO 3.

NO>>

  1. Satisfy the condition.

  2. GO TO 3.

PERFORM COMPONENT FUNCTION CHECK

Perform component function check. Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Refer to DTC Diagnosis Procedure.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and warm it up to normal operating temperature.

  2. Hold Nissan Ariya vehicle speed at more than 40 km/h (25 MPH) for 180 consecutive seconds.

    CAUTION:

    Always drive Nissan Ariya vehicle at a safe speed.

  3. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK REFRIGERANT PRESSURE SENSOR

Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace refrigerant pressure sensor. Refer to Removal and Installation.

    P0531 A/c Refrigerant Pressure Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0531 00 REFRIGERANT PRESS SENSOR A (A/C refrigerant pressure se...
    P054a Camshaft Position Bank 1
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P054A 00 Cold start B camshaft position bank 1 (Cold start B cam...

    Other materials:

    Exhaust Valve Timing Control Solenoid Valve
    Component Inspection CHECK EXHAUST VALVE TIMING (EVT) CONTROL SOLENOID VALVE-1 Turn ignition switch OFF. Disconnect EVT control solenoid valve harness connector. Check the resistance between EVT control solenoid valve terminals as per the following. EVT control solenoid valve Cond ...

    Removal and Installation. Combination Switch
    Removal and Installation REMOVALRemove steering angle sensor. Refer to Removal and Installation. Disconnect harness connector from combination switch. Remove the combination switch mounting screw . Pull out the combination switch by moving it alternately on the right and left side. CAUTIO ...

    C1061-02 Wheel Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1061 02 FR LH wheel sensor (Front left wheel sensor) Diagnosis condition When ignition switch is ON. When front left wheel sensor power supply voltage ...