Nissan Rogue (T33) 2021-Present Service Manual: P11aa Vcr Position Learning

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P11AA 00

VCR position learning

(Variable compression ratio position learning)
Diagnosis condition Ignition switch ON
Signal (terminal)
Threshold
Diagnosis delay time 3 seconds or more

POSSIBLE CAUSE

  • VCR control module

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If the other DTC Confirmation Procedure is performed right before this procedure, the ignition switch must be turned OFF and wait for 10 seconds or more to start this procedure.

YES>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 10 seconds.

  2. Check 1st trip DTC.

Is DTC P11AA detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

PERFORM VCR BASE POSITION LEARNING

  1. Start engine.

  2. Perform VCR base position learning.

  3. Perform DTC confirmation procedure.

Is the DTC P11AA displayed again?

YES>>

Replace VCR control module. Refer to VCR CONTROL MODULE : Removal & Installation.

NO>>

INSPECTION END

    P11a9 Vcr Target Angle
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P11A9 00 VCR target angle (Variable compression ratio target ang...
    P11ab Vcr Control Module Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P11AB 00 VCR control module circuit (Variable compression ratio ...

    Other materials:

    Ignition Coil, Spark Plug and Rocker Cover
    Exploded View Ignition coil Spark plug Cover (right) Rocker cover gasket Rocker cover gasket Rocker cover Clamp Resonator hose Turbo hose Blow-by hose PCV valve O-ring Oil filler cap Oil filler gasket 1 Oil filler gask ...

    Evap Canister Vent Control Valve
    Component Inspection CHECK EVAP CANISTER VENT CONTROL VALVE-1 Disconnect hose from (A), (B), and (C) with remaining harness connector connected. Block port (B). Blow air into port (A) and check that it flows freely out of port (C). Is sufficient air flowed from port (C)? YES& ...

    Basic information
    Precautions on child restraints WARNING Failure to follow the warnings and instructions for proper child restraint use and installation can lead to serious injury or death to a child or other passengers in a sudden stop or collision inside the Nissan Rogue: The child restraint must alw ...