Nissan Rogue (T33) 2021-Present Service Manual: Vin Registration

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Basic Inspection / Vin Registration

Description

VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced.

NOTE:

Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M).

Work Procedure

CHECK VIN

Check the VIN of the vehicle and note it. Refer to Information About Identification or Model Code.

>>

GO TO 2.

PERFORM VIN REGISTRATION

With CONSULT

  1. Turn ignition switch ON and engine stopped.

  2. Select “VIN REGISTRATION” in “WORK SUPPORT” mode of “ENGINE”.

  3. Follow the instruction of CONSULT display.

>>

END

    Additional Service When Replacing Ecm
    Description When replacing ECM, the following procedure must be performed.CAUTION: When replacing the ECM, always replace it with a new one. The functions controlled by the ECM ...
    Accelerator Pedal Released Position Learning
    Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal p...

    Other materials:

    Blind Spot Warning (BSW)
    Basic information WARNING Failure to follow the warnings and instructions for proper use of the Blind Spot Warning system could result in serious injury or death. The BSW system is not a substitute for safe driving practices. It cannot prevent collisions with nearby vehicles or objects. Always c ...

    P00d2 Ho2s2 Heater
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P00D2 00 Heated O2 sensor heater B1 sensor 2 (HO2S heater control circuit range/performance bank 1 sensor 2) Diagnosis condition — Signal (terminal) ...

    Dtc/circuit Diagnosis. Wiper Deicer Relay
    Component Function Check CHECK WIPER DEICER RELAY POWER SUPPLY CIRCUIT CONSULT Ignition switch ON. Select "Front window defogger (passenger side)" and "Front window defogger (driver side)" in "Active test" mode of "BCM". Select “On”. Check that the front window heating wire ...