Nissan Rogue (T33) 2021-Present Service Manual: Mixture Ratio Self-Learning Value Clear

Description

This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure�. (For details, refer to Work Procedure.)

Work Procedure

START

With CONSULT

  1. Start engine and warm it up to normal operating temperature.

  2. Select “Air fuel ratio learning value clear� in “WORK SUPPORT� mode of “ENGINE� using CONSULT.

  3. Clear mixture ratio self-learning value by touching “CLEAR�.

With GST

  1. Start engine and warm it up to normal operating temperature.

  2. Turn ignition switch OFF.

  3. Disconnect mass air flow sensor harness connector.

  4. Restart engine and let it idle for at least 5 seconds.

  5. Stop engine and reconnect mass air flow sensor harness connector.

  6. Select Service $03 with GST. Make sure DTC P0102 is detected.

  7. Select Service $04 with GST to erase the DTC P0102.

>>

END

    Turbocharger Wastegate Control Solenoid Valve Data Initialization
    Description ECM learns a turbocharger wastegate valve position at every engine start to perform more accurate boost control.Learning value of turbocharger wastegate valve positi...
    Mac Key Writing
    Description When replacing ECM, it is necessary to write MAC key to ECM. Write MAC key to ECM according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Wo...

    Other materials:

    Propilot Assist 2.1. Basic Inspection
    Diagnosis and Repair Work Flow Work Flow OVERALL SEQUENCEDETAILED FLOWINTERVIEW FOR MALFUNCTION It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully. NOTE: The customers ar ...

    Bose Speaker Amp.
    Reference Value VALUES ON THE DIAGNOSIS TOOLNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor Item Condition Value/Status Active sound control oper ...

    U218b Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms DTC detection condition U218B 83 CAN communication error Diagnosis condition Ignition switch ON Signal (terminal) CAN communication signal 87 Threshold ECM is not transmitting or receiving CAN com ...