Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Ign Off Interlock Door Unlock Function Does Not Operate

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Symptom Diagnosis :: Ign Off Interlock Door Unlock Function Does Not Operate

Diagnosis Procedure

CHECK “AUTO DOOR UNLOCK” SETTING IN COMBINATION METER

Check “Auto Door Unlock” setting is “IGN OFF”.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Set “IGN OFF” in combination meter.

REPLACE BCM

  1. Replace BCM. Refer to Removal and Installation.

  2. Confirm the operation after replacement.

Is the result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

    Symptom Diagnosis. Ignition Position Warning Function Does Not Operate
    Diagnosis Procedure CHECK POWER DOOR LOCK OPERATION Check door lock/unlock using door lock/unlock switch. Does door lock/unlock with door lock/unlock switch? YES>> GO TO 2...
    Symptom Diagnosis. Key Reminder Function Does Not Operate
    Diagnosis Procedure CHECK DOOR SWITCH Check door switch. Refer to Component Function Check. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replac...

    Other materials:

    It Can Communication 1 Circuit
    Diagnosis Procedure CHECK NETWORK DIAGNOSIS Check the "Network diagnosis" results from CONSULT to see that the diagnostic CAN communication circuit have no malfunction. Are the diagnostic CAN communication circuit normal? YES>> GO TO 2. NO>> Check and repair diagnostic CAN commu ...

    Type a. Removal and Installation
    Combination Meter Removal and Installation CAUTION: When replacing the combination meter, always replace it with a new one. The functions controlled by the combination meter does not operate properly in case of reuse of the combination meter from another Nissan Ariya vehicle. Be su ...

    P1574 Propilot Assist Vehicle Speed Sensor
    DTC Description The ECM receives two ProPILOT Assist vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (tramsmission control module). The ECM uses these signals for ProPILOT Assist control. Refer to System Description.DTC DE ...