Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Power Supply and Ground Circuit. Sonar Control Unit

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Sonar System / Dtc/circuit Diagnosis :: Power Supply and Ground Circuit. Sonar Control Unit

Sonar Control Unit

Diagnosis Procedure

CHECK FUSE

Check that the following fuse is not blown (open).

Power source Fuse No. Capacity
ACC power supply #40 10 A

Is the fuse blown (open)?

YES>>

Be sure to eliminate cause of malfunction before installing new fuse.

NO>>

GO TO 2.

CHECK IGNITION POWER SUPPLY CIRCUIT

  1. Turn ignition switch ON.

  2. Check voltage between sonar control unit harness connector and ground.

    (+) (-) Standard Reference value
    Sonar control unit
    Connector Terminal
    B20 12 Ground 9.0 - 16.0 V Battery voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace sonar control unit power supply harness.

CHECK GROUND CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect sonar control unit connector.

  3. Check continuity between sonar control unit harness connector and ground.

    Sonar control unit Ground Continuity
    Connector Terminal
    B20 15 Existed

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Repair or replace sonar control unit ground harness.

    U2a05-88 Can Comm Circuit
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...
    Symptom Diagnosis. Sonar System Symptoms
    Symptom Table Symptom Possible cause Reference page Malfunction is detected in only 1 sensor of display. Sonar sensor circuit Sonar sensor Perform CONSULT self-diagnosis. Perfor...

    Other materials:

    Régulateur de vitesse
    Informations de base Fonction de RES+ Fonction de SET- Touche CANCEL Commande marche/arrêt (ON/OFF) de régulateur de vitesse AVERTISSEMENT Respectez toujours les limitations de vitesse en vigueur et ne réglez jamais la vitesse du régulateur au-delà des limites autorisées ...

    Symptom Diagnosis. Automatic Back Door Functions Do Not Cancel
    Diagnosis Procedure CHECK “POWER BACK DOOR SETTING” IN COMBINATION METER Check “Power back door setting” is in the OFF. Is the inspection result normal? YES>> GO TO 2. NO>> Set “Power back door setting” to “OFF”. REPLACE AUTOMATIC BACK DOOR CONTROL UNIT Rep ...

    Dysfonctionnement du système
    En cas de dysfonctionnement du système d'intervention de changement de voie intelligent, celui-ci est automatiquement désactivé. Le témoin du système d'intervention de changement de voie intelligent (orange) s'allume, un signal sonore retentit et le message d'avertissement « Défaut du systèm ...