Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Sonar System Symptoms

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Sonar System / Symptom Diagnosis :: Sonar System Symptoms

Symptom Table

Symptom Possible cause Reference page
Malfunction is detected in only 1 sensor of display.

  • Sonar sensor circuit

  • Sonar sensor

 Perform CONSULT self-diagnosis. Perform detected DTC self-diagnosis. Refer to DTC Index.
Front sonar sensors do not activate. Front sensor power supply and ground circuit Check front sensor power supply and ground circuit. Refer to Diagnosis Procedure.
Rear sonar sensors do not activate. Rear sensor power supply and ground circuit Check rear sensor power supply and ground circuit. Refer to Diagnosis Procedure.
Malfunction is detected in all sensors of display. Sonar control unit power supply and ground circuits

Check sonar control unit power supply and ground circuit.

Refer to Diagnosis Procedure.

When there is no malfunction in those components, replace the sonar control unit.

Refer to Removal and Installation.
    Dtc/circuit Diagnosis. Power Supply and Ground Circuit. Sonar Control Unit
    Sonar Control Unit Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown (open). Power source Fuse No. Capacity ACC power supply #40 10 A Is the fuse blown (...
    Symptom Diagnosis. Normal Operating Condition
    Description Symptom Possible cause Unstable object detection The Nissan Ariya vehicle is on a rough surface, such as stone or gravel. When used in poor weather conditions, such ...

    Other materials:

    Dtc/circuit Diagnosis. U1fa1-86 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U1FA1 86 CAN communication error (ADAS control unit) 1 Diagnosis condition When Ignition switch is ON. Signal (terminal) CAN communication signal Threshold When a malfunction ...

    Engine oil
    Checking engine oil level Park the vehicle on a level area and apply the parking brake. Warm up the engine to operating temperature. Shut the engine off and wait at least 10 minutes. Remove the dipstick, wipe it clean, then fully reinsert it. Remove the dipstick again and check the oil le ...

    U2384 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2384 83 CAN comm err (eVTC) [CAN comm err (eVTC)] Diagnosis condition Ignition switch ON Signal (terminal) CAN communication signal 87 Thresho ...