Nissan Rogue (T33) 2021-Present Service Manual: Mac Key Writing

Description

When replacing ECM, it is necessary to write MAC key to ECM. Write MAC key to ECM according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.

CAUTION:

During MAC key writing, maintain the following conditions:

  • Ignition switch ON

  • CONSULT is connected to internet

Work Procedure

PERFORM MAC KEY WRITING

  1. Ignition switch ON.

  2. Select "MAC Key writing" on "Work Support" of "ECM" using CONSULT.

  3. Touch "Write".

YES>>

INSPECTION END

    Mixture Ratio Self-Learning Value Clear
    Description This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure�. (For details, refe...
    Engine Oil Data Reset
    Description The oil control system allows calculating the remaining distance to drive before oil change request. The engine oil data reset must be performed after engine oil is ...

    Other materials:

    Limites du système RAB
    AVERTISSEMENT Les limites du système de freinage automatique arrière (RAB) du Nissan Rogue sont décrites ci-dessous. Le non-respect des instructions et avertissements relatifs à l’utilisation correcte du système RAB peut entraîner des blessures graves, voire mortelles. Le conducteur doit to ...

    Removal and Installation. Filament
    Inspection and Repair INSPECTIONWhen measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. Attach probe circuit tester (in Volt range) to middle portion of each filament. If a filament is burned out, circuit teste ...

    B20d4-11 Tail Lamp Lh Pwr Sply Circ
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B20D4–11 TAIL LAMP LH PWR SPLY CIRC (Tail lamp left hand power supply circuit) [CIRCUIT SHORT TO GROUND] Diagnosis condition When the parking lamp, license pla ...