Nissan Rogue (T33) 2021-Present Service Manual: Engine Oil Data Reset

Description

The oil control system allows calculating the remaining distance to drive before oil change request. The engine oil data reset must be performed after engine oil is changed.

CAUTION:

Never reset data except when changing engine oil.

NOTE:

Data cannot be reset until the vehicle travels 10 km (6.2 mile) from the previous data reset.

Work Procedure

START

  1. Turn ignition switch ON.

  2. Check information display of the combination meter.

Is Distance to Engine Oil Change displayed?

YES>>

GO TO 3.

NO>>

GO TO 2.

SELECT OIL CONTROL SYSTEM MODE

Push the Display next switch and select oil control system mode.

>>

GO TO 3.

RESET ENGINE OIL DATA

  1. Press and hold the Display Next switch at least 1 second while Distance to Engine Oil Change is displayed.

  2. Stop pressing the Display Next switch, and a few seconds later, check that the value of Distance to Engine Oil Change is reset.

>>

END

    Mac Key Writing
    Description When replacing ECM, it is necessary to write MAC key to ECM. Write MAC key to ECM according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Wo...
    Fuel Pressure Check
    Work Procedure FUEL PRESSURE RELEASEFUEL PRESSURE RELEASE With CONSULT Turn ignition switch ON. Perform “ENGINE� in “WORK SUPPORT� mode with CONSULT. Start the engine. A...

    Other materials:

    Dtc/circuit Diagnosis. B2436-12 Spindle Motor Lh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2436-12 Spindle motor LH (Spindle motor left hand) Diagnosis condition All times Signal (terminal) Spindle motor LH signal Threshold When automatic ...

    C1f89-97 Side Radar Rear Lh
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1F89 97 Side radar rear LH (Side radar rear left hand) Diagnosis condition When engine is running Signal (terminal) CAN communication signal Threshold ...

    Front Wheel Hub and Knuckle
    Exploded View Steering knuckle Splash guard Hub bolt Wheel hub and bearing assembly Disc rotor Wheel hub lock nut A. : Comply with the installation procedure when tightening. Refer to Removal and Installation. : N·m (kg-m, ft-lb) : Always replace ...