Nissan Rogue (T33) 2021-Present Service Manual: Electric Ivt Control Actuator Position Learning
Description
Electric intake valve timing control (IVT) module requires the learning of camshaft reference position.
This learning must be performed where the following operations are performed:
-
Replacement of electric IVT control module
-
Replacement of intake/exhaust camshaft position sensor
-
Replacement of crankshaft position sensor
-
Removal and installation of timing chain
-
Replacement of the mechanical parts listed below:
-
Replacement of timing chain
-
Replacement of intake/exhaust camshaft
-
Replacement of intake/exhaust camshaft sprocket
-
Replacement of piston
-
Replacement of connecting rod
-
Replacement of crankshaft
-
NOTE:
If learning is not performed after the replacement of the above listed parts, the engine may not be able to be started.
Work Procedure
START
Do you have CONSULT?
YES>>GO TO 2.
NO>>GO TO 3.
ELECTRIC INTAKE VALVE TIMING (IVT) CONTROL ACTUATOR REFERENCE POSITION LEARNING
With CONSULT
-
Turn ignition switch ON.
-
On CONSULT screen, select All DTC Reading and check that any DTC is not detected.
-
Select “Electric intake valve timing control learning” in “WORK SUPPORT” of “ENGINE”.
-
Touch “Start” and start the engine within 10 seconds.
-
Let the engine be idle.
-
Check that “COMPLETED” is displayed.
Is the learning completed normally?
YES>>END
NO>>Check that DTC is not detected and restart the learning.
PERFORM ELECTRIC IVT CONTROL ACTUATOR REFERENCE POSITION LEARNING
Without CONSULT
-
Turn ignition switch OFF.
-
Disconnect electric IVT control actuator harness connector (actuator side).
-
Turn ignition switch ON and wait at least 30 seconds.
-
Turn ignition switch OFF.
-
Reconnect the disconnected harness connector.
-
Start engine and let it idle at least 15 seconds.
-
Turn ignition switch OFF.
-
Check and erase DTC.
>>
END
Other materials:
Precaution. Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along with a front seat belt, helps to reduce the
risk or severity of injury to the driver and front passeng ...
P2a01 Ho2s2
DTC Description
The heated oxygen sensor 2 has a much longer switching time between
rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage
capacity of the three way catalyst (manifold) causes the longer
switching time.MALFUNCTION ATo judge the malfunctions of
heated oxygen ...
Egr Temperature Sensor
Component Inspection
CHECK EGR TEMPERATURE SENSOR
Turn ignition switch OFF.
Disconnect EGR temperature sensor harness connector.
Remove EGR temperature sensor.
Check resistance between EGR temperature sensor terminals.
EGR temperature sensor Condition Resistance
+ − ...
