Nissan Rogue (T33) 2021-Present Service Manual: Rear View Monitor :: Symptom Diagnosis. Rear View Monitor System

Rear View Monitor System

Symptom Table

REAR VIEW MONITOR

Symptoms Possible cause Inspection item

Camera image is not shown.

(Nissan Ariya Vehicle width and predictive course line are displayed.)
  • Harness between rear view camera and AV control unit

  • Rear view camera

  • AV control unit

  • Camera power supply circuit. Refer to Diagnosis Procedure.

  • Camera image signal circuit. Refer to Diagnosis Procedure.

Camera image does not switch.
  • CAN communication

  • AV control unit

  • TCM

Perform “Self Diagnostic Result” of “MULTI AV" with CONSULT. Refer to CONSULT Function.
    Rear View Monitor. Dtc/circuit Diagnosis
    Power Supply and Ground Circuit Av Control Unit Diagnosis Procedure CHECK FUSE Turn ignition switch OFF. Check that the following fuse is not blown (open) Power source Fuse No. ...
    Rear View Monitor. Removal and Installation. Rear View Camera
    Rear View Camera Removal and Installation REMOVALRemove the back door inner finisher. Refer to Removal and Installation. Remove the rear view camera mounting bolts , And then pu...

    Other materials:

    Power Distribution System. Ecu Diagnosis Information. Bcm, Ipdm E/r, Intelligent Key Unit
    Bcm, Ipdm E/r, Intelligent Key Unit List of ECU Reference ECU Reference BCM Reference Value Fail-safe DTC Inspection Priority Chart DTC Index IPDM E/R Values on the Diagnosis Tool Reference Value Fail-safe DTC Inspection Priority Chart DTC Index ...

    2wd. Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
    Noise, Vibration and Harshness (nvh) Troubleshooting NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference DRIVE SHAFT FRONT AXLE Noise Shake Noise Shake Vibration ...

    C1051-04 Pump Motor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1051 04 Pump motor (Pump motor) Diagnosis condition When ignition switch is ON. When the power supply voltage is normal. Signal (terminal) ...