Nissan Rogue (T33) 2021-Present Service Manual: P2b96 Injection Pulse

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P2b96 Injection Pulse

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P2B96 00 Injection pulse Diagnosis condition —
Signal —
Threshold ECM does not control fuel injection quantity properly when engine is running (except engine cold start).
Diagnosis delay time 1 second

POSSIBLE CAUSE

ECM

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

Start engine and drive the Nissan Ariya vehicle as per the similar conditions to Freeze Frame Data for 5 seconds. Hold the accelerator pedal as steady as possible.

CAUTION:

Always drive Nissan Ariya vehicle in safe manner according to traffic conditions and obey all traffic laws when driving.

  • COOLANT TEMP

  • ENGINE SPEED

  • CAL/LD VALUE

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

REPLACE ECM

  1. Replace ECM. Refer to ECM : Removal & Installation.

  2. Refer to Work Procedure.

>>

INSPECTION END

    P2b95 Cold Start Control
    DTC Description ECM controls fuel injection timing and fuel injection quantity when engine is started with the engine cold.This control promotes the activation of three way cata...
    P2c91 Crankcase Ventilation System
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2C91 00 Crankcase Ventilation System - Hose "B" Disconnected (C...

    Other materials:

    Ecu Diagnosis Information. Power Steering Control Module
    Reference Value VALUES ON THE DIAGNOSIS TOOLNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor item Data monitor Condition Display value Steering ...

    Dtc/circuit Diagnosis. Door Lock Actuator
    Front Lh Diagnosis Procedure CHECK DOOR LOCK ACTUATOR INPUT SIGNAL Ignition switch OFF. Disconnect front door lock assembly LH connector. Check voltage between front door lock assembly LH harness connector and ground. (+) (–) Condition Voltage (Approx.) Front door lock a ...

    Vehicle information display warnings and indicators
    Engine start operation indicator This indicator appears when the shift position is set to P (Park). It informs the driver that the engine will start when the ignition switch is pushed while depressing the brake pedal. The Nissan Rogue engine can be started directly in any ignition switch position. ...