Nissan Rogue (T33) 2021-Present Service Manual: Rear View Monitor :: Removal and Installation. Rear View Camera

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Audio, Visual & Navigation System / Rear View Monitor :: Removal and Installation. Rear View Camera

Rear View Camera

Removal and Installation

REMOVAL

Remove the back door inner finisher. Refer to Removal and Installation.

Remove the rear view camera mounting bolts , And then push the pawls in the direction of the arrow in the figure to remove the rear view camera.

INSTALLATION

Installation is in the reverse order of removal.

    Rear View Monitor. Symptom Diagnosis. Rear View Monitor System
    Rear View Monitor System Symptom Table REAR VIEW MONITOR Symptoms Possible cause Inspection item Camera image is not shown. (Nissan Ariya Vehicle width and predictive course lin...
    Intelligent Around View Monitor. Precaution. Precautions
    Precautions Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT P...

    Other materials:

    System Description. System
    System Description An Electrically-driven Intelligent Brake Unit is a booster system that generates assist force by using an internal motor to operate a piston inside the master cylinder part. Control module is integrated with Electrically-driven Intelligent Brake Unit. The amount ...

    Rear Final Drive: R145. Unit Removal and Installation. Rear Final Drive Assembly
    Rear Final Drive Assembly Exploded View Final drive mounting bracket Mounting stopper Rear final drive assembly : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVALNOTE: When replacing AWD control unit (integrated with act ...

    Low Pressure Fuel Pump
    Component Function Check CHECK LOW PRESSURE FUEL PUMP FUNCTION Turn ignition switch ON. Pinch fuel feed hose with two fingers. Fuel pressure pulsation should be felt on the fuel feed hose for 1 second after ignition switch is turned ON. Is the inspection result normal? YES ...