Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: System Initialization

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Roof / Basic Inspection :: System Initialization

Description

Initialization of system should be conducted after the following conditions: Refer to Work Procedure.

  • When the moonroof motor assembly or sunshade motor assembly is replaced.

  • When the moonroof or sunshade does not operate normally. (Incomplete initialization conditions)

Work Procedure

PERFORM SYSTEM INITIALIZATION

  1. Close moonroof and sunshade.

  2. Press and hold the moonroof switch CLOSE for apporximately 10 seconds.

    Moonroof and sunshade will move as following:

    Moonroof tilt up, and the sunshade slightly close and stops.

  3. Release the moonroof switch, and continue to press the moonroof switch CLOSE again soon.

    Moonroof and sunshade will move as following:

    Sunshade fully open → moonroof tilt down → moonroof fully open → moonroof fully closed → sunshade fully closed.

  4. Release the moonroof switch after moonroof and sunshade stopped.

>>

GO TO 2.

CHECK THE FUNCTION

  1. Check that moonroof and sunshade automatically operated normally.

  2. Check anti-pinch function. Refer to Description.

>>

End

    Basic Inspection. Diagnosis and Repair Work Flow
    Work Flow OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incid...
    Basic Inspection. Anti-Pinch Inspection
    Description Check anti-pinch function when the initialization of moonroof and sunshade system is performed. Refer to Work Procedure. Work Procedure CHECK ANTI-PINCH FUNCTION Ful...

    Other materials:

    Diagnosis System (around View Monitor Control Unit)
    Consult Function CONSULT FUNCTIONSCONSULT performs the following functions via the communication with the around view monitor control unit. Diagnosis mode Function Self diagnosis result The around view monitor control unit self diagnosis results are displayed. ECU identification The ...

    Change of System Mode
    Description CAUTION: When the following operations are performed, always use CONSULT, for performing “SYSTEM MODE CHANGE” of “WORK SUPPORT”. Refer to Work Procedure. ×: Required —: not required Procedure SYSTEM MODE CHANGE Removing/installing ABS actuator and electric unit (c ...

    Removal and Installation. Front Disc Brake
    Brake Pad Exploded View WITHOUT ProPILOT Assist 2.1 Cylinder body Inner shim cover Inner shim Inner pad (with pad wear sensor) Return spring Pad retainer Torque member Outer pad Outer shim Outer shim cover         ...