Nissan Rogue (T33) 2021-Present Service Manual: C1f00-1c Control Unit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
C1F00 1C

CONTROL UNIT

(Control unit)
Diagnosis condition When engine is running
Signal (terminal)
Threshold ADAS control unit 2 internal malfunction
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

ADAS control unit 2

FAIL-SAFE

The following systems are canceled.

  • Vehicle-to-vehicle distance control mode

  • Conventional (fixed speed) cruise control mode

  • Steering wheel assistance function

  • AEB

  • RAB

  • I-FCW

  • LDW

  • I-LI

  • BSW

  • I-BSI

  • RCTA

  • TSR

  • I-DA

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine.

  2. Perform “All DTC Reading” with CONSULT.

  3. Check if the “C1F00-1C” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.

Is DTC “C1F00-1C” detected?

YES-1>>

“CRNT” is displayed: Refer to DTC Diagnosis Procedure.

YES-2>>

“PAST” is displayed: Check the 12V battery. Refer to Work Flow.

NO-1 >>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2 >>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK SELF-DIAGNOSIS RESULTS

Check if any DTC other than “C1F00-XX”, is detected in “Self Diagnostic Result” of “ICC/ADAS 2”.

Is any DTC detected?

YES>>

Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index.

NO>>

GO TO 2.

CHECK 12V BATTERY

Check 12V battery. Refer to Work Flow.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace the 12V battery. Refer to Removal and Installation.

PERFORM THE SELF-DIAGNOSIS

CONSULT

  1. Ignition switch OFF (Auto ACC function ON).

  2. Get out of the Nissan Ariya vehicle, close all doors (other than hood), check that the combination meter is OFF, and wait for 1 minute or more without opening these doors.

    CAUTION:

    Never operate the Nissan Ariya vehicle.

  3. Ignition switch ON without depressing the brake pedal.

  4. Perform self-diagnosis for “ICC/ADAS 2”.

Is “C1F00-1C” detected as the current malfunction?

YES>>

Replace the ADAS control unit 2. Refer to Removal and Installation.

NO>>

Inspection End. (Erase the memory of self-diagnosis results.)

    Adas Control Unit. Dtc/circuit Diagnosis
    C1f00-44 Control Unit
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition   C1F00 44 CONTROL UNIT (Contro...

    Other materials:

    Dtc/circuit Diagnosis. Lin Communication Circuit
    Diagnosis Procedure CHECK BCM OUTPUT SIGNAL Ignition switch ON. Check signal between BCM harness connector and ground using an oscilloscope. (+) (−) Signal (Reference value) BCM Connector Terminal With type A meter: B123 91 Ground With type B meter: M18 ...

    Symptom Diagnosis. Wiper Deicer Does Not Operate
    Diagnosis Procedure CHECK WIPER DEICER RELAY Check wiper deicer relay. Refer to Component Inspection. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. CHECK WIPER DEICER Check wiper deicer. Refer to Component Function Check. I ...

    Front Camera Unit Heater
    Component Inspection CHECK FRONT CAMERA UNIT HEATER Check the resistance between the front camera unit heater terminals. Front camera unit heater Resistance [Ω] Terminal 1 4 7 – 20 Is the inspection result normal? YES>> INSPECTION END NO>> Replace the fro ...