Nissan Rogue (T33) 2021-Present Service Manual: Vcr Base Position Learning
Description
VCR control module requires the learning of VCR base position.
This learning must be performed where the following operations are performed:
-
Replacement of VCR control module
-
Replacement of VCR actuator
Work Procedure
PRECONDITIONING
Check that all of the following conditions are satisfied.
-
Engine oil temperature: 60°C (140°F) or more
-
Engine running: idle speed
-
Accelerator pedal: Full released
YES>>
GO TO 2.
PERFORM VCR BASE POSITION LEARNING
With CONSULT
-
Select “VCR base position learning� in “WORK SUPPORT� mode of “ENGINE� using CONSULT.
-
Touch “START�.
Is “CMPLT� displayed on CONSULT screen?
YES>>GO TO 3.
NO>>Check that DTC is not detected and restart the learning.
ERASE DTC
Without CONSULT
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Erase DTC.
>>
END
Other materials:
Sièges, ceintures de sécurité et systèmes de retenue supplémentaires (SRS)
Dans le Nissan Rogue, la sécurité des occupants repose sur l’association des ceintures, des appuie-tête et des dispositifs SRS (airbags et capteurs). Reportez-vous toujours aux avertissements du manuel avant toute intervention sur un composant SRS.
Airbags avant : protection frontale du ...
Limites du système RAB
AVERTISSEMENT
Les limites du système de freinage automatique arrière (RAB) du Nissan Rogue sont décrites ci-dessous. Le non-respect des instructions et avertissements relatifs à l’utilisation correcte du système RAB peut entraîner des blessures graves, voire mortelles. Le conducteur doit to ...
Transfer: Ty92a. Service Data and Specifications (sds). Service Data and Specifications (sds)
Service Data and Specifications (sds)
General Specifications
Applied model Axle AWD
Engine KR15DDT
Transaxle CVT
Transfer model
TY92A
Gear ratio
0.404
Number of teeth
Ring gear
42
Drive pinion
17
Oil capacity
Refer to Fluids and Lubricants.
...
