Nissan Rogue (T33) 2021-Present Service Manual: C1f04-61 Brake Sw/stop Lamp Sw

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Adas Control Unit :: Dtc/circuit Diagnosis / C1f04-61 Brake Sw/stop Lamp Sw

Without Propilot Assist 2.1

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
 
C1F04 61

FEB OPE COUNT LIMIT

(Forward Emergency Braking operation count limit) 		Diagnosis condition

  • When AEB system is ON

  • When driving at the Nissan Ariya vehicle speeds of approximately 40 km/h or more.
Signal (terminal) —
Threshold A mismatch between a stop lamp switch signal and a brake pedal position switch signal received from BCM
Diagnosis delay time 60 seconds or more

POSSIBLE CAUSE

  • BCM

  • ADAS control unit 2

FAIL-SAFE

The following systems are canceled.

  • Vehicle-to-vehicle distance control mode

  • Conventional (fixed speed) cruise control mode

  • Steering wheel assistance function

  • AEB

  • RAB

CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC “C1F04-61” is displayed with Network-DTC, first diagnose the Network-DTC.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

GO TO 2 .

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine.

  2. Turn the AEB system ON.

  3. Perform “All DTC Reading” with CONSULT.

  4. Check if the “C1F04-61” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.

Is “C1F04-61” detected as the current malfunction?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

With Propilot Assist 2.1

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
 
C1F04 61 FEB OPERATION COUNT LIMIT Diagnosis condition When driving at the Nissan Ariya vehicle speeds of approximately 40 km/h or more.
Signal (terminal) Stop lamp switch signal
Threshold A mismatch between a stop lamp switch signal and a brake pedal position switch signal received from BCM
Diagnosis delay time 60 seconds or more

POSSIBLE CAUSE

  • BCM

  • ADAS control unit 2

FAIL-SAFE

The following systems are canceled.

  • Vehicle speed & vehicle-to-vehicle control function

  • Lane keep function*1

  • Lane keep function*2

  • Lane change support function

  • Overtaking support function

  • Route driving support function

  • FEB

  • RAB

  • PFCW

  • TSR

*1: ProPILOT Assist 2.1 display is green

*2: ProPILOT Assist 2.1 display is blue

CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC “C1F04-61” is displayed with Network-DTC, first diagnose the Network-DTC.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

GO TO 2 .

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine.

  2. Drive the Nissan Ariya vehicle at 40 km/h (25 MPH) or more, and keep 60 seconds or more.

    NOTE:

    Always drive safely.

  3. Perform “All DTC Reading” with CONSULT.

  4. Check if the “C1F04-61” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.

Is “C1F04-61” detected as the current malfunction?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1 >>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2 >>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK DTC PRIORITY

If DTC “C1F04-61” is displayed with Network-DTC, first diagnose the Network-DTC.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

GO TO 2 .

CHECK BCM SELF-DIAGNOSTIC RESULT

CONSULT

Check if any DTC is detected in “Self Diagnostic Result” mode of “BCM”.

Is any DTC detected?

YES>>

Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index .

NO>>

Replace the ADAS control unit 2. Refer to Removal and Installation.

    C1f04-48 Feb Ope Count Limit
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition   C1F04 48 FEB OPE COUNT LIMIT ...
    C1f05-04 Front Camera Unit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1F05 04 Front camera unit (Front camera unit) Diagnosis conditi...

    Other materials:

    Removal and Installation. Automatic Back Door Switch
    Removal and Installation REMOVALRemove the instrument lower panel LH. Refer to Removal and Installation. Remove screws and then remove the switch bracket from the instrument lower panel LH. Remove automatic back door switch from the switch bracket. : Pawl INSTALLATIONInstallati ...

    Key Reminder Function
    System Description SYSTEM DIAGRAMBASIC OPERATIONKey reminder is the function that prevents the key from being left in the vehicle.Key reminder has the following 2 functions. Key remainder function Operation condition Operation Front door LH closed* When all doors other than front door LH ar ...

    Symptom Diagnosis. Automatic Back Door Functions Do Not Cancel
    Diagnosis Procedure CHECK “POWER BACK DOOR SETTING” IN COMBINATION METER Check “Power back door setting” is in the OFF. Is the inspection result normal? YES>> GO TO 2. NO>> Set “Power back door setting” to “OFF”. REPLACE AUTOMATIC BACK DOOR CONTROL UNIT Rep ...