Nissan Rogue (T33) 2021-Present Service Manual: U2952-88 Ethernet Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Adas Control Unit :: Dtc/circuit Diagnosis / U2952-88 Ethernet Circuit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
 
U2952 88 Ethernet communication error Diagnosis condition When engine is running
Signal (terminal) Ethernet communication
Threshold Detects interruptions to Ethernet communication circuits
Diagnosis delay time 5 seconds or more

POSSIBLE CAUSE

  • Ethernet harness

  • ADAS control unit 2

  • CGW

FAIL-SAFE

None

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine, and then wait for 5 seconds or more.

  2. Perform “All DTC Reading” with CONSULT.

  3. Check if the DTC “U2952-88” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.

Is DTC “U2952-88” detected as the current malfunction?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1 >>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK ETHERNET CABLE

  1. Turn the ignition switch OFF.

  2. Check the Ethernet cable of ADAS control unit 2 for disconnection, bending, and poor fitting.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace ethernet cable.

    U2852-88 Ethernet Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2852 88 Ethernet circuit (Ethernet circuit) Diagnosis condition...
    U2b52-88 Ethernet Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2B52 88 Ethernet comm err Diagnosis condition When engine is ru...

    Other materials:

    C1b80-54 Control Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1B80 54 Calibration not completed Diagnosis condition When ignition switch is ON. Signal (terminal) - Threshold When calibration is not complete. Diagnosis delay time 1 ...

    Removal and Installation. Driver Air Bag Module
    Exploded View 1. Steering wheel 2. Driver air bag module     Removal and Installation WARNING: Always observe the following items for preventing accidental activation. Before servicing, place the ignition switch in the OFF position, disconnect main battery negat ...

    Informations de base
    Sélecteur mode de conduite : Modèles 4x2 Sélecteur mode de conduite : Modèles avec transmission intégrale Écran d'informations du véhicule : Modèles 4x2 Écran d'informations du véhicule : Modèles avec transmission intégrale Le Nissan Rogue propose plusieurs ...