Nissan Rogue (T33) 2021-Present Service Manual: C1f5f-08 Distance Sensor
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| C1F5F | 08 |
Distance sensor (Distance sensor) |
Diagnosis condition | When engine is running |
| Signal (terminal) | — | |||
| Threshold | Distance sensor is malfunctioning | |||
| Diagnosis delay time | 5 seconds or more | |||
POSSIBLE CAUSE
-
Distance sensor
-
ADAS control unit 2
FAIL-SAFE
The following systems are canceled.
-
Vehicle-to-vehicle distance control mode
-
Conventional (fixed speed) cruise control mode
-
Steering wheel assistance function
-
AEB
-
I-FCW
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
-
Start the engine.
-
Perform “All DTC Reading” with CONSULT.
-
Check if the “C1F5F-08” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.
Is “C1F5F-08” detected as the current malfunction?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK DISTANCE SENSOR SELF-DIAGNOSIS RESULTS
Check if any DTC is detected in “Self Diagnostic Result” of “LASER/RADAR”.
Is any DTC detected?
YES>>Refer to DTC Index.
NO>>GO TO 2.
CHECK ADAS CONTROL UNIT 2 SELF-DIAGNOSIS RESULTS
Check if the “C1F5F-08” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.
Is “C1F5F-08” detected?
YES>>Replace ADAS control unit 2. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
Accelerator Pedal Position Sensor
Component Inspection
CHECK ACCELERATOR PEDAL POSITION SENSOR
Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Turn ignition switch ON.
Check the voltage between ECM harness connector terminals as per the following condition.
ECM Condition
Voltage
(A ...
Ignition Signal
Component Function Check
INSPECTION START
Turn ignition switch OFF, and restart engine.
Does the engine start?
YES-1>>
With CONSULT: GO TO 2.
YES-2>>
Without CONSULT: GO TO 3.
NO>>
Refer to Diagnosis Procedure.
CHECK IGNITION SIGNAL FUNCTION-1
With CONSULT
Perfor ...
Entretien général
Informations de base
Lors de l’utilisation normale de votre Nissan Rogue, les opérations d’entretien général doivent être réalisées régulièrement et avec rigueur, conformément aux instructions décrites dans cette section. Toute apparition de bruits anormaux, de vibrations inhabituelle ...