Nissan Rogue (T33) 2021-Present Service Manual: C1f37-55 Switch Information

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
C1F37 55

Switch information

(Switch information)
Diagnosis condition When engine is running
Signal (terminal) —
Threshold ADAS control unit 2 internal malfunction
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

ADAS control unit 2

FAIL-SAFE

The following systems are canceled.

  • Vehicle speed & vehicle-to-vehicle control function

  • Lane keep function*1

  • Lane keep function*2

  • Lane change support function

  • Overtaking support function

  • Route driving support function

  • FEB

  • RAB

  • PFCW

  • LDP

  • Blind Spot Intervention

  • TSR

  • DAA

*1: ProPILOT Assist 2.1 display is green

*2: ProPILOT Assist 2.1 display is blue

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine.

  2. Perform “All DTC Reading� with CONSULT.

  3. Check if the “C1F37-55� is detected as the current malfunction in “Self Diagnostic Result� of “ICC/ADAS 2�.

Is “C1F37-55� detected as the current malfunction?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair:Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK SELF-DIAGNOSIS RESULTS

Check if any DTC other than “C1F37-55�, is detected in “Self Diagnostic Result� of “ICC/ADAS 2�.

Is any DTC detected?

YES>>

Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index.

NO>>

Replace the ADAS control unit 2. Refer to Removal and Installation.

    C1f36-55 Configuration
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition   C1F36 55 CONFIG UNFINISHED (C...
    C1f40-04 Ecm
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition   C1F40 04 ECM (Engine control ...

    Other materials:

    Dtc/circuit Diagnosis. Door Lock Actuator
    Front Lh Diagnosis Procedure CHECK DOOR LOCK ACTUATOR INPUT SIGNAL Ignition switch OFF. Disconnect front door lock assembly LH connector. Check voltage between front door lock assembly LH harness connector and ground. (+) (–) Condition Voltage (Approx.) Front door lock a ...

    Led Headlamp. Removal and Installation
    Headlamp Exploded View REMOVAL Radiator core support Headlamp Front combination lamp Front fender assembly Protector tape (USA production models)     : Always replace after every disassembly. : N·m (kg-m, in-lb) DISASSEMBLYFront turn signal la ...

    Removal and Installation. Rear Power Window Switch
    Removal and Installation CAUTION: Never bend the fixing pawl of power window switch finisher. REMOVALRemove power window switch finisher. Refer to Removal and Installation. Remove rear power window switch from power window switch finisher . : Pawl INSTALLATIONInstall in the reverse ...