Nissan Rogue (T33) 2021-Present Service Manual: C1f00-47 Control Unit
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| C1F00 | 47 |
CONTROL UNIT (Control unit) |
Diagnosis condition | When engine is running |
| Signal (terminal) | — | |||
| Threshold | ADAS control unit 2 internal malfunction | |||
| Diagnosis delay time | 1 second or less | |||
POSSIBLE CAUSE
ADAS control unit 2
FAIL-SAFE
The following systems are canceled.
-
Vehicle-to-vehicle distance control mode
-
Conventional (fixed speed) cruise control mode
-
Steering wheel assistance function
-
AEB
-
RAB
-
I-FCW
-
LDW
-
I-LI
-
BSW
-
I-BSI
-
RCTA
-
TSR
-
I-DA
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
-
Start the engine.
-
Perform “All DTC Reading” with CONSULT.
-
Check if the “C1F00-47” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.
Is “C1F00-47” detected as the current malfunction?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK SELF-DIAGNOSIS RESULTS
Check if any DTC other than “C1F00-XX” is detected in “Self Diagnostic Result” of “ICC/ADAS 2”.
Is any DTC detected?
YES>>Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index.
NO>>Replace the ADAS control unit 2. Refer to Removal and Installation.
Other materials:
AEB with Pedestrian Detection system operation
AEB emergency warning indicator
Vehicle ahead detection indicator (on the vehicle information display)
AEB system OFF warning light (on the meter panel)
Steering-wheel-mounted controls (left side)
The AEB with Pedestrian Detection system on the Nissan Rogue operates when the vehicle is dr ...
Basic Inspection. System Initialization
Description
Initialization of system should be conducted after the following conditions: Refer to Work Procedure.
When the moonroof motor assembly or sunshade motor assembly is replaced.
When the moonroof or sunshade does not operate normally. (Incomplete initialization conditions)
Wor ...
Additional Service When Replacing Distance Sensor
Work Procedure
Always perform the distance sensor configuration after replacing the distance sensor.
Always perform the radar alignment after removing and installing or replacing the distance sensor.
CAUTION:
The system does not operate normally unless the distance
sensor configuration ...