Nissan Rogue (T33) 2021-Present Service Manual: U19b2-88 Lin Comm Circuit
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| U19B2 | 88 |
LIN communication error (LIN communication error) |
Diagnosis condition | When engine is running |
| Signal (terminal) | LIN communication signal | |||
| Threshold | ADAS control unit 2 detects a steering wheel touch sensor voltage error | |||
| Diagnosis delay time | 2 seconds or more | |||
POSSIBLE CAUSE
-
Steering wheel touch sensor
-
ADAS control unit 2
FAIL-SAFE
The following systems are canceled.
-
Steering wheel assistance function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
-
Start the engine, and then wait for 2 seconds or more.
-
Perform “All DTC Reading” with CONSULT.
-
Check if the “U19B2-88” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.
Is “U19B2-88” detected as the current malfunction?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK DTC PRIORITY
If DTC “U19B2-88” is displayed with Network-DTC, first diagnose the Network-DTC.
Is applicable DTC detected?
YES>>Perform diagnosis of applicable. Refer to DTC Index.
NO>>GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
Perform confirmation procedure again. Refer to DTC Description.
Is “U19B2-88” detected as the current malfunction?
YES>>Replace the ADAS control unit 2. Refer to Removal and Installation.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
Other materials:
Parking brake
Basic information
WARNING
Never drive the vehicle with the parking brake applied. The brake will overheat and fail to operate and will lead to an accident.
Never release the parking brake from outside the vehicle. If the vehicle moves, it will be impossible to push the foot brake pedal and will l ...
Ecv (electrical Control Valve)
Diagnosis Procedure
CHECK FUSE
Ignition switch OFF.
Check that the following fuse is not blown (open).
Unit Location Fuse No. Capacity
A/C compressor
IPDM E/R
71
10 A
Is the fuse blown (open)?
YES>>
Replace the blown (open) fuse after repairing the af ...
Symptom Diagnosis. Driver Side Power Window Does Not Operate
Diagnosis Procedure
CHECK POWER WINDOW MAIN SWITCH POWER SUPPLY AND GROUND CIRCUIT
Check power window main switch power supply and ground circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHE ...
