Nissan Rogue Owners Manual: Starting and driving
- Precautions when starting and driving
- Exhaust gas (carbon monoxide)
- Three-way catalyst
- Tire Pressure Monitoring System (TPMS)
- Avoiding collision and rollover
- Off-road recovery
- Rapid air pressure loss
- Drinking alcohol/drugs and driving
- Driving safety precautions
- Ignition switch (if so equipped)
- Push-Button Ignition Switch (if so equipped)
- Operating range
- Push-button ignition switch positions
- NISSAN Intelligent Key® battery discharge (if so equipped)
- NISSAN vehicle immobilizer system
- Before starting the engine
- Starting the engine (models without NISSAN Intelligent Key® system)
- Starting the engine (models with NISSAN Intelligent Key® system)
- Driving the vehicle
- Parking brake
- ECO mode switch (if so equipped)
- Blind Spot Warning (BSW) System / Lane Departure Warning (LDW) System (if so equipped)
- Cruise control
- Forward Collision Warning (FCW) system (if so equipped)
- Break-in schedule
- Fuel efficient driving tips
- Intelligent 4WD (if so equipped)
- Parking/parking on hills
- Power steering
- Brake system
- Vehicle Dynamic Control (VDC) system
- Chassis Control
- Hill Descent Control System (if so equipped)
- Hill start assist system
- Cold weather driving
Navigation System voice commands
The following voice commands are available for
the Navigation System:
Street Address (address)
Points of Interest (name)
POI by Category
Home
Address Book
...
Precautions when starting and driving
WARNING
Do not leave children or adults who
would normally require the assistance
of others alone in your vehicle. Pets
should also not be left alone. They
could accid ...
Other materials:
Performance test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFC-134a) or
manifold gauge.
Start the engine, and set to the following condition.
Test condition
Maintain test condition until A/C system becomes stable. (Approximately
10 minute ...
EPS warning lamp
Component Function Check
1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP
Check that the EPS warning lamp turns ON when ignition switch turns ON. Then,
EPS warning lamp turns
OFF after the engine is started.
Is the inspection result normal?
YES >> Inspection End.
NO >> Perfor ...
Circuit inspection
DESCRIPTION
In general, testing electrical circuits is an easy task if it is
approached in a logical and organized method.
Before beginning it is important to have all available information on the
system to be tested. Also, get a thorough
understanding of system operation. Then y ...
