Nissan Rogue Owners Manual: Three-way catalyst

Nissan Rogue Owners Manual / Starting and driving / Precautions when starting and driving / Three-way catalyst

The three-way catalyst is an emission control device installed in the exhaust system. Exhaust gases in the three-way catalyst are burned at high temperatures to help reduce pollutants.

WARNING

The exhaust gas and the exhaust system are very hot. Keep people, animals or flammable materials away from the exhaust system components.
Do not stop or park the vehicle over flammable materials such as dry grass, waste paper or rags. They may ignite and cause a fire.

CAUTION

Do not use leaded gasoline. Deposits from leaded gasoline will seriously reduce the three-way catalyst’s ability to help reduce exhaust pollutants.
Keep your engine tuned up. Malfunctions in the ignition, fuel injection, or electrical systems can cause overrich fuel flow into the three-way catalyst, causing it to overheat. Do not keep driving if the engine misfires, or if noticeable loss of performance or other unusual operating conditions are detected. Have the vehicle inspected promptly by a NISSAN dealer.
Avoid driving with an extremely low fuel level. Running out of fuel could cause the engine to misfire, damaging the three-way catalyst.
Do not race the engine while warming it up.
Do not push or tow your vehicle to start the engine.

Exhaust gas (carbon monoxide)

WARNING Do not breathe exhaust gases; they contain colorless and odorless carbon monoxide. Carbon monoxide is dangerous. It can cause unconsciousness or death. &nb ...

Tire Pressure Monitoring System (TPMS)

Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by the vehicle manufacturer on the vehicle placard or tire infl ...

Other materials:

Main power window and door lock/unlock switch
Removal and Installation REMOVAL Remove the front door pull handle bracket (LH). Refer to INT-15, "Removal and Installation". Release pawls using a suitable tool (A) and remove main power window and door lock/unlock switch finisher (1). : Pawl Disconnect t ...

P0101 MAF sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0101 MAF SEN/CIRCUIT-B1 (Mass or volume air Flow ″A″ circuit range/ performance) A high voltage from the sensor is sent to ...

Fuse inspection
How To Check If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse. Use fuse of specified rating. Never use fuse of more than specified rating. Do not partially install fuse; always insert it into fuse holder properly. Remove fus ...