LOCK (Normal parking position):
The ignition switch can only be locked in this position.
The ignition switch will lock when any door is opened or closed with the ignition switched off.
ON (Normal operating position):
This position turns on the ignition system and electrical accessories.
ON has a battery saver feature that will turn the ignition switch to the OFF position, if the vehicle is not running, after some time under the following conditions:
The battery saver feature will be cancelled if any of the following occur:
| CAUTION Do not leave the vehicle with the ignition switch in the ON position when the engine is not running for an extended period. This can discharge the battery. |
OFF:
The ignition switch is in the OFF position when the engine is turned off using the ignition switch.
No lights will illuminate on the ignition switch.
AUTO ACCESSORY:
With the vehicle in the P (Park) position, the Intelligent key with you and the ignition placed from ON to OFF, the radio can still be used for a period of time, or until the driver’s door is opened.
After a period of time, functions such as radio, navigation, and Bluetooth® Hands-Free Phone System may be restarted by pressing the “POWER button/ VOLUME control knob”. For additional information, refer to “Monitor, climate, audio, phone and voice recognition systems” in this manual or the keyfob unlock button up to a total of 30 minutes.
Emergency engine shut off
To shut off the engine in an emergency situation while driving, perform the following procedure:
Operating range
NISSAN Intelligent Key® battery discharge
(if so equipped)P0444, P0445 EVAP canister purge volume control solenoid
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0444
PURG VOLUME CONT/V
(Evaporative emission system purge control
valve circuit open)
An excessively low voltage signal is sent to ECM through ...
Removal and installation
AUDIO UNIT
Exploded View
Audio unit bracket (LH)
Audio unit
Audio unit bracket (RH)
Removal and Installation
REMOVAL
Disconnect the negative battery terminal. Refer to PG-75, "Removal
and Installation (Battery)".
Remove A/C switch (AUTOMATIC AI ...
Air flow charts
The following charts show the button and dial
positions for MAXIMUM AND QUICK heating,
cooling or defrosting. The air recirculation indicator
should always be in the OFF position
for heating and defrosting.
...