Nissan Rogue Service Manual: Engine
- Engine Mechanical
- Precaution
- Symptom diagnosi
- Preparation
- Periodic maintenance
- Removal and installation
- Unit removal and installation
- Unit disassembly and assembly
- Service data and specifications (SDS)
- Engine Lubrication System
- Precaution
- Preparation
- System description
- Periodic maintenance
- Removal and installation
- Service data and specifications (SDS)
- Engine Cooling System
- Precaution
- Preparation
- System description
- Symptom diagnosis
- Periodic maintenance
- Removal and installation
- Service data and specifications (SDS)
- Engine Control System
- Precaution
- Preparation
- System description
- Ecu diagnosis information
- Wiring diagram
- Basic inspection
- DTC/Circuit diagnosis
- Symptom diagnosis
- Periodic maintenance
- Removal and installation
- Service data and specifications (sds)
- Fuel System
- Exhaust System
- Starting System
- Precaution
- Preparation
- System description
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- Removal and installation
- Accelerator Control System
Consult/gst checking system
Description
NOTE:
This vehicle is diagnosed using the CONSULT-III plus.
When CONSULT is connected with a data link connector equipped
on the vehicle side, it will communicate with the co ...
Other materials:
Washer motor circuit
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW-22, "Wiring Diagram".
1. CHECK FRONT AND REAR WASHER MOTOR FUSE
Turn the ignition switch OFF.
Check that the following fuse is not blown.
Is the fuse blown?
YES >> Replace the blown fuse ...
Door switch
WITH INTELLIGENT KEY
WITH INTELLIGENT KEY : Component Function Check
1.CHECK FUNCTION
Select "DOOR LOCK" of "BCM" using CONSULT.
Select "DOOR SW-DR", "DOOR SW-AS", "DOOR SW-RL", "DOOR SW-RR", in
"Data Monitor&quo ...
Air cleaner
Air cleaner
The air cleaner filter should not be cleaned and
reused. Replace it according to the maintenance
log shown in the “NISSAN Service and Maintenance
Guide.”
To remove the air cleaner filter:
Unlatch the retaining clips A .
Pull up at points B and remove.
...
