Nissan Rogue manuals

Nissan Rogue Service Manual: Preparation

Special Service Tools

The actual shape of the tools may differ from those illustrated here.

Tool number (Kent-Moore No.) Tool name

Description

(J-44321) Fuel pressure gauge kit

Checks fuel pressure
KV10120000 Fuel tube adapter

Measures fuel pressure

Commercial Service Tools

Tool name (Kent-Moore No.)

Description
Leak detector i.e.: (J-41416)

Locates the EVAP leak
EVAP service port adapter i.e.: (J-41413-OBD)

Applies positive pressure through EVAP service port
Fuel filler cap adapter i.e.: (MLR-8382)

Checks fuel tank vacuum relief valve opening pressure
Socket wrench

Removes and installs engine coolant temperature sensor
Oxygen sensor thread cleaner i.e.: (J-43897-18) (J-43897-12)

Reconditions the exhaust system threads before installing a new oxygen sensor. Use with antiseize lubricant shown below.

a: 18 mm diameter with pitch 1.5 mm for Zirconia Oxygen Sensor
b: 12 mm diameter with pitch 1.25 mm for Titania Oxygen Sensor

Anti-seize lubricant i.e.: (PermatexTM 133AR or equivalent meeting MIL specification MIL-A-907)

Lubricates oxygen sensor thread cleaning tool when reconditioning exhaust system threads.
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

System description
...

Other materials:

Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any custome ...

Intermittent incident
DESCRIPTION Sometimes the symptom is not present when the vehicle is brought in for service. If possible, re-create the conditions present at the time of the incident. Doing so may help avoid a No Trouble Found Diagnosis. The following section illustrates ways to simulate the conditions/envi ...

Moonroof switch
Removal and Installation REMOVAL  Remove map lamp assembly. Refer to INL-55, "Removal and Installation".  Using a suitable tool release clip from harness connector. : Clip Using a suitable tool release pawls and remove moonroof switch finisher (1). Using a ...

© 2014-2020 Copyright www.nirogue.com